WEGO III DN Wide-Band AFR Sensor Interface (dual channel interface
unit without internal data logging or LED display. Intended for automotive use with an existing data acquisition system)
IMPORTANT NOTE! – DO NOT ATTEMPT to clean any O2 sensor in gasoline or any type of solvent! Doing so will VOID any warranty. Please contact the Daytona Sensors Tech Dept. if you have any questions about this topic.
• Complete air/fuel ratio (AFR) display system with built-in data logging
• Displays Lambda or correct AFR values for any hydrocarbon fuel with a known stoichiometric ratio
• Input for optional customer supplied flex fuel sensor. A switch under the sensor 2 LED allows selection of normal AFR display or 0-100% ethanol display
• Measurement range is 10.3 to 19.5 gasoline AFR or 0.70 to 1.33 Lambda
• Highly accurate with less ±0.10 AFR or ±0.007 Lambda error over entire range
• Easy free-air calibration procedure corrects for sensor aging effects
• 0-5V analog AFR outputs for interface to dyno instrumentation
• Waterproof ultra bright daylight readable blue LED display with automatic dimming under low light conditions
• Wide supply voltage range from 11-16V allows operation from battery on small engines and race vehicles without an alternator. Current drain is under 2 amps