1979-Up GM Metric Stock Car Disc Brake Rotor, 5 on 5 Inch, DRP

Brake Rotor

This 1979-up GM Metric front disc brake rotor will work with a Set # 6 inner bearing/race which fits most spindles. 5 on 5" with 5/8" coarse studs installed. 10.5" diameter x 1".  Must be used with 912-TS3 outer bearings for 1982-1987 spindle applications.  IMCA Approved.

This is a 1979-1981 Metric GM rotor with the bolt pattern changed to 5 on 5". It can be used on 1982-1987 GM metric spindles if the you use our bearing/seal kit 91031048, or use at least the 1979-1981 style outer bearing 912TS3.

This rotor is designed for dirt track applications and should NOT be used for asphalt racing.

Bearing Spacer

• Designed to fit '79-up GM Metric spindles
• Allows your front hubs to be tight with minimal drag and side pre-load
• Easy adjust threaded sleeve and set screw ensure you'll never worry about an over-tightened front hub again

Bearings and Seal

Bearing Kit for GM #2 Metric Front (SET3/6); DRP Premium Finished

Includes:

• (1) LM67048
• (1) M12649
• Seal OD: 2.565"
• Seal ID: 1.950" (Our sealing elements are full PTFE and "stretch" over the spindle)
• Seal Width: 0.255"

 

Kit Includes

(1) 1979-Up GM Metric Stock Car Disc Brake Rotor, 5 on 5 Inch

(1) DRP 007 10521S 1979-Up GM Metric Spindle Pre-Load Bearing Spacers

(1) DRP 007-10581 Premium Finished GM Metric Front Bearing Kit

(1) DRP Performance Products 007 10577 Ultra Low Drag Hub Seal

(1) DRP 007-10756 Ultra Low Drag Bearing Grease Syringe, 50 Grams