1948-60 Ford Pickup EFI Fuel Tank Kit

Fuel Pump Module

Fuel your EFI/LS swap with this Speedway Motors in-tank fuel pump module. This submersible fuel pump module features a billet aluminum top plate and has an adjustable tank depth of up to 16 inches.

• Billet aluminum top plate
• Walbro GSS340 fuel pump
• 255 LPH free flow rate
• 40-70 PSI operating pressure
• Adjustable tank depth up to 16"
• 5-3/4" O.D. mount flange
• Flange features 16 holes on 5" diameter bolt circle
• AN6 Threaded pressure and return ports

 

Fuel Cap

As featured on Classic Truck’s Week to Wicked. Watch the transformation here!

Polished billet aluminum pop-up flush mount gas cap is 2-1/2" O.D., 1.600" tall, and works with a 1-1/2" hose.

• Can be left popped up or flush down against the body
• Works with 1-1/2" filler neck hose
• Non-vented cap design - gas tank vent is recommended

The Pop-Up gas cap, 910-12521, does not have a vent hole.  Some air might get past the threads that hold the cap on, but there is no dedicated venting passage.

 

Sending Unit

These sending units are also included in our 910-65042 fuel level gauge kit. They will work in tanks from 6" to 24" deep and can be used as a right hand or left hand swing unit with minor adjustment.  This fuel sender comes with a seal and all mounting hardware. 

• 240 ohms empty, 33 ohm full
• Adjustable depth from 6" to 24"
• Right or left hand swing
• 2-3/4" flange OD
• Overall Length: 15.50"
• Includes sealing gasket and mounting hardware

Learn more about selecting the proper fuel sending unit by reading our tech article, Fuel Sending Units.

 

Instructions (PDF)

910-12521 Dimensions (PDF)

Fuel Level Gauge Installation Instructions

Fuel Level Sender Installation Instructions