Panhard Bar Bracket, 3 Inch Tube Clamp
Click image to enlarge
Q & A
What's in the Box
You may also be interested in:
BSB Manufacturing 7055-20 Steel Frame SliderPrice: $84.99More Info
Straight Panhard BarMore Info
Panhard-Behind Rear End Bracket - Weld OnMore Info
Panhard Bar MountPrice: $29.99More Info
BSB Manufacturing 7043 Extra Long Panhard BarPrice: $74.99More Info
BSB Manufacturing 7053 Adjustable Panhard Bar Axle Mount, 3 Inch Tube ClampMore Info
Single Panhard Mount, 2 Inch Square TubeMore Info
Behind Rear End Panhard Bar Bracket - Clamp OnMore Info
This steel panhard frame slider allows you to move panhard bar without changing length. Available for 1-1/2" and 2" .
Straight steel panhard bar, 26-1/2" eye-to-eye. With 3/4" heims.
Note: When using these bars, your specific application my require the use of heim spacers for maximum range of motion. Spacing out the mounting tabs prevents the heim joint body from making contact with the them. This provides for greater misalignment (range of motion) without decreasing hole size.
If your application requires the use of misalignment spacers then 910-07000 would be the best one for you. It is ½” thick and when you use one on each side of the heim they will add a total of 1” of thickness. 910-07001 could also be used if you need to space out further from your mounting point as it is 1” thick.
These behind rear end panhard bar brackets have four 3/4" holes for changing roll center and panhard bar angle. Fits 3" axle tube. Weld-on.
This steel panhard bar mount clamps onto 1-1/2" square tubing. Accepts 3/4" heim. Forged steel. Yellow zinc plated.
This extra long panhard bar only has one end installed allowing you to custom fit for your car. Has 3/4" rod ends and is 30" center to center.
This adjustable panhard bar axle mount clamps to 3" axle tubes and gives you 3" of adjustment. Works with 916-45580 panhard bar. Stud is 3/4". Steel.
These panhard bar mounts make it easy to adjust or change your set-up. They each have two 1/2" mounting bolts and accept a 3/4" panhard bolt. Single pick-up points.
These behind rear end panhard bar brackets have four 3/4" holes for changing roll center and panhard bar angle. Fits 3" axle tube. Clamp-on.