DVD - Richmond Gear Installation Instruction
Click image to enlarge
Q & A
What's in the Box
Applications covered include:
- Chrysler 8.25", 8.75" and 9.25"
- Corvette 1955-present
- Dana 28-44-60
- Ford 7.50", 8", 8.8", 9"
- GM 10 Bolt
- GM 12 Bolt car and truck
Easy to follow guide changing rear gears
- Easy to follow
- Full of information
No questions have been asked.
You may also be interested in:
Assembly Stand for 9 Inch Ford DifferentialMore InfoCompare
Ford 9 Inch Econo Ring & Pinion Set-Up Tool KitMore InfoCompare
Pro Ring & Pinion Setup Tool SetMore InfoCompare
Mount this assembly stand to your work bench (or engine stand) and stop wrestling with the third member every time you need to replace a gear set or spool. Saves you time and energy! Rotates 360° for total access to your assembly.
All the special tools needed to install your ring and pinion: a dial indicator with stand, yoke lock/carrier bearing nut wrench.
Resolution accuracy is .001
910-82720 Instructions (pdf)
The most accurate ring and pinion set up tool available. It uses the same bearing the carrier uses to insure proper center line to pinion measurement. Does not assume that the cap is on the center as other tools do.
Comes complete with indicator to set back lash, wooden storage box and instructions on proper usage.
- Designed for pinion depths for 1.00" to 3.00"
- Works on GM 10 and 12 bolt, 8.8 and 9" Ford, 3.25 and 8.75 Mopar
- Dans with lower number than 60 and most other passenger car rear ends and small trucks
910-82725 Instructions (pdf)