We found a limited supply of new small yokes for the 9" Ford. They accept the 1310 series U-joints (1-1/16" caps x 3-7/32"). Fits standard 28 spline pinion gear.
Longer slip yokes help compensate for extreme travel rear suspension set-ups or driveshaft lengths slightly shorter than needed. Works with 1310 series U-joints. Fits over the output shaft of the following transmissions:
Longer slip yokes help compensate for extreme travel rear suspension set-ups or driveshaft lengths slightly shorter than needed. Works with 1310 series U-joints.
Fits over the output shaft of the following transmissions:
High quality, heat treated forged steel replacement U-joints. The endcaps on the 3-5/8" width side have grooves for "inside clips." There are no grooves on the 3-7/32" width endcaps, therefore that side MUST use external clips. All four clips included.
High quality, heat treated forged steel replacement U-joints. This u-joint only works with clips outside the end caps. Clips included. The caps do not have grooves for clips.
Stock length (5-1/2") slip yoke for GM applications with 1-3/16" x 27-spline output shaft. Works with 1310 series U-joints.
The expressed measurement or length of the slip yoke is taken from the center of the u-joint to tip, not overall.
Longer slip yokes help compensate for extreme travel rear suspension set-ups or drive shaft lengths slightly shorter than needed. Yoke is grooved for external u-joint cap retaining clips. Works with 1310 series U-joints.This front driveshaft slip yoke measures 6-3/4" from the centerline of the u-joint to the front edge. Length of machined part of yoke is 4-3/4".Fits over the output shaft of the following transmissions:
Longer slip yokes help compensate for extreme travel rear suspension set-ups or drive shaft lengths slightly shorter than needed. Yoke is grooved for external u-joint cap retaining clips. Works with 1310 series U-joints.This front driveshaft slip yoke measures 6-3/4" from the centerline of the u-joint to the front edge. Length of machined part of yoke is 4-3/4".
Longer slip yokes help compensate for extreme travel rear suspension set-ups or driveshaft lengths slightly shorter than needed. Yoke is grooved for "external" snap rings to retain U-joint cups. Works with 1310 series U-joints. Fits over the output shaft of the following transmissions:
Longer slip yokes help compensate for extreme travel rear suspension set-ups or driveshaft lengths slightly shorter than needed. Yoke is grooved for "external" snap rings to retain U-joint cups. Works with 1310 series U-joints.