1967 Chevy Chevelle Suspension Bushings

Get more details on Project Chevelle's 9-inch housing, third member, and tubular control arms installation.

Jeff demonstrates how to install a high quality rear trailing arm kit for his 1967 Chevelle. Learn more about the a-body rear suspension and its unique set of requirements. Find out how to eliminate wheel hop and promote “forward bite”.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

Follow this guide on how to install a splined sway bar for GM A-body applications. See the installation process on a '68 Chevelle frame using stock control arms and factory chassis bolt and pad locations.

See how Jeff installs Hedman mid-length headers to the big block in his '67 Chevelle. Learn about the modifications made to the steering shaft and the clamp on the lower steering column for a successful application.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Follow this guide on how to mount a single electric puller fan in a '66 - '67 Chevelle. Learn tips on taking measurements and installing a rubber spacer to prevent the fan from rubbing.

Installation guide for Speedway Motors 9" Bolt-In Rear End Axle on a 1967 Chevelle. This housing allows the use of any coil-over conversion made to work with a factory housing. Learn how to fasten the third member into the housing with studs.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

See how Jeff converts his 1967 Chevelle rear suspension to QA1 double adjustable coil-over suspension. This allows added adjustability for ride height and compression and rebound characteristics.