Tru-Square Micro Sprint Rearend Alignment Tool, 2" Axle
Set your rear axle on your setup blocks of choice. Be sure your spacers are on and your rear axle nuts are tight so the birdcages are not loose.
The Tru-Square tool clamps to the axle directly above the setup blocks, therefore the tool that is needed is determined by the overall diameter of the axle or axle spacer (if applicable) at this location. Measure the diameter of your rear axle or the diameter of the spacer (if there is a spacer on the axle) directly above the set up blocks. Your measurements should be:
- 2" (on both sides)
- 2.5" (on both sides)
- 2" on one side and 2.5" on the other
This fits long spline axles which have axle/wheel spacers covering the axle at the point of tool contact on both sides of the axle.
- Quick attachment system for rear end squaring
- All aluminum construction
- Hardware is included
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
Q & A
Jason Martin explains how to square the front end of a sprint car. He walks through the step by step process of squaring the front axle, adjusting the radius rods and setting the side to side. Check it out!
Learn the proper method of blocking a race car in this step-by-step procedure to follow when performing this task. Learn why consistency is important and a few "not-to-do's".
Our hot rod expert takes you through his ford I beam axle setup. Follow as he sets up the front end on his split wishbone front suspension Model A.