Speedway 1979-Up GM Metric Stock Car Disc Brake Rotor, 5 on 5 Inch
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
This 1979-up GM Metric front disc brake rotor will work with a Set # 6 inner bearing/race which fits most spindles. 5 on 5" with 5/8" coarse studs installed. 10.5" diameter x 1". Must be used with 912-TS3 outer bearings for 1982-1987 spindle applications. IMCA Approved.
This is a 1979-1981 Metric GM rotor with the bolt pattern changed to 5 on 5". It can be used on 1982-1987 GM metric spindles if the you use our bearing/seal kit 91031048, or use at least the 1979-1981 style outer bearing 912TS3.
This rotor is designed for dirt track applications and should NOT be used for asphalt racing.
Item Details5 on 5"
Proper Break-In Procedure for Steel or Cast Iron Rotors
New steel/iron rotors should be bedded in before being used in racing conditions. Proper bedding will prepare the rotor surface, prolong the rotor's life, and make it more resistant to thermal checking or cracking under severe braking conditions. The following procedures should be performed when bedding in both steel and cast iron rotors. It is best to bed in a new rotor using a used set of pads, preferably ones which will not create heat rapidly. Generating heat too rapidly will thermal shock the rotors. Likewise, when bedding in a new set of brake pads it is best to perform the process on a used rotor. This new/used bedding process permits controlled bedding of each individual component.
Make sure rotor surfaces are free from oils, grease, and brake fluid. Run vehicle up to a moderate speed and make several medium deceleration stops to heat up the rotor slowly. This will help reduce the chance of thermal shock caused by uneven heating of the rotor. Pull into the pits and allow the rotor to cool to ambient air temperature. Care should be taken not to ride the brakes into the pits as this may hot spot the rotor causing premature wear to the surface or structural damage.
More Like This
AFCO 9850-6500 GM Metric Style Brake Rotors 1979 and Up, 5 x 5 Inch
Wilwood 160-9239 HP Modified Hub/Rotor, Vented w/Studs, 10.50 Inch
1973-77 GM Midsize 11 Inch Brake Rotor, 5 on 5 Inch
Speedway 10 Inch Hybrid Brake Rotor for Pinto
Low Friction Oil Bath 10 Inch Hybrid Brake Rotor
Speedway Dirtworks 10.5 Inch Granada Style Disc Brake Rotor
1979-Up GM Metric Brake Rotor, 5 on 4-3/4 In, 5/8-11 In Coarse Studs
1979-1981 GM Midsize 10 1/2 Inch Disc Brake Rotors
Wilwood 160-9240 HP Modified Hybrid Hub/Rotor, Vented w/Studs, 10.15
Low Friction Oil Bath 10 Inch Hybrid Brake Rotor Kit