Holley 16-108 HydraMat Fuel Pickup, 8 X 3 Inch, Rectangle
Universal Fit, 3" Overall Width, 8" Overall Length
Holley introduces its line of amazing patent pending HydraMat fuel pickups that solve the problems associated with traditional fuel pick-ups in stock fuel tanks as well as racing fuel cells. During hard cornering, acceleration, stopping, inclines, and low fuel conditions fuel runs away from the fuel pick up which introduces air into the system resulting in poor engine performance and even stalling. HydraMat is the perfect solution to this problem!
Surface tension and fluid wicking are the secrets of the HydraMat, giving it the amazing ability to draw from nearly any area that has contact with fuel and then store it in its internal reservoir. As an area of the HydraMat is uncovered, the tiny pores of the media seal off through surface tension, forcing fuel to be contained in the reservoir and drawn from other areas of the mat where fuel continues to be available. The sheer size and coverage area of the HydraMat allows it to pull fuel from virtually any area in the tank or cell eliminating the need for specialty reservoirs and pick up pumps saving cost and greatly reducing complexity.
- 3/8" NPT fitting size
- 8 inch length
- 3 inch width
- Center outlet
- Rectangle shape
For best performance, the return fuel should be discharged near the pick-up of the HydraMat at a minimum distance of 1 inch above the mat.
HydraMats with a female NPT thread do not require the use of a sealing paste or tape. Use of a sealing paste or tape could result in fuel pump failure.
This part is legal for use on Uncontrolled (Non-Emissions Controlled) Vehicles or Racing Vehicles.
Hydromat Selection Guide (PDF)
Hydromat Instructions (PDF)
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
More Like This
Holley 16-105 HydraMat Fuel Pickup, 15 X 3 Inch, Rectangle
Holley 16-103 HydraMat Fuel Pickup, 8 X 8 Inch, Cross
Holley 16-101 HydraMat Fuel Pickup, 15 x 8 Inch, Cross
Holley 16-203 HydraMat Install Magnet Kit, 4-40 Thread
Holley 16-104 HydraMat Fuel Pickup, 11x11 Inch, Cross
Holley 16-100 HydraMat Fuel Pickup, 15x15 Inch, Cross
Holley 12-132 In-Tank Retrofit Fuel Module, 450 LPH
Holley 16-121 30 x 14 Inch HydraMat, Rectangle with Notch Out
Holley 16-102 HydraMat Fuel Pickup, 15 X 8 Inch, Offset Outlet
Holley 16-106 HydraMat Fuel Pickup, 11 X 11 Inch, Square
Q & A
We take a look at some parts going into a 1951 Chevy Truck project. We highlight a few key pieces including the 1947-1954 Chevy Truck EFI Fuel tank.
Pat talks about our Tanks Inc. EFI fuel tanks.
Now that Project Chevelle is making some real power, we've decided to ditch the old tank, lines, and pump in favor of a new tank and pump from Tanks Inc.
Speedway Motors and Classic Trucks built a 1952 Chevy truck in celebration of the 65th anniversary of Speedway Motors. Check out the short video on one of the products used in the build.