HVH Super Sucker 4150 Carburetor 4-Hole Spacer, 2 Inch
Universal Fit, 2" Overall Thickness, 5.160" x 5.625" Bolt Hole Pattern, Not Gasket(s) Included
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
Designed by Joe Petelle at HVH over 15 years ago for Winston Cup engines, this spacer will increase air speed from the base of the carburetor to the top of the intake valve, pulling more fuel from the carburetor, the Super Sucker will require a change in the size jet currently being used. E.T. is reduced as much as 1/10 of a second and lap times reduced as much as 2/10 of a second.
Improvements in the throttle response, driveability, top end horsepower and torque are commonplace when using a Super Sucker.
This 2" aluminum spacer is specifically designed for 4150 series carburetors and gives more mid end and high range torque without reducing top end torque.
- 2" tall
- Lightweight aluminum
- 8-20 HP gain
- Sold each
More Like This
Holley Aluminum 1 Inch Carburetor Spacer, 4-Hole
Plastic Insulating Carb Spacer for Holley 4150/4160, 1 Inch
Plastic Open Carburetor Spacer, 2 Inch
Plastic Insulating Carb Spacer for Holley 4150/4160, 2 Inch
Speedway Phenolic 4-Hole 1 Inch Carburetor Spacer
Speedway Phenolic 4-Hole 1/2 Inch Carburetor Spacer
1 Inch Aluminum Open Carburetor Spacer
High Flow 4150 Holley Carb Spacer
Plastic Open Carburetor Spacer, 1 Inch
Speedway Phenolic Open 1/2 Inch Carburetor Spacer
Q & A
In this episode, Project Chevelle takes a big step in its muscle car transformation. It's out with the little old 307 and to the dyno with our new 383 from BluePrint Engines!
Tim talks about Edmunds air cleaners and the history of Edmunds.
Tim talks about his favorite intake manifold, the Might Edelbrock X1.