EMi Stallard® Micro Sprint Rearend Alignment Tool

These centering tools allow you to install a rear end in a chassis without being hooked up to a motor plate. This is helpful when setting up an extra chassis before heading to the track.  This tool is specifically made for all types of micro chassis!

• Round hole is for the rear axle
• 1 3/4" notch is for the front axle
• Small hole is for the round rods

Rear squaring:
1. Set left and right torsion arm lengths with fixture
2. Hook torsion arms to torsion bars without stops
3. Hook torsion arms to bearing carriers
4. Adjust radius rods to proper lengths and hook to bearing carriers
5. Now unhook torsion arms
6. With a protractor rotate bearing carriers 57 degrees
7. Re-attach torsion arms (arms may need to be lengthened or shortened)