Cast Iron 9 Inch Ford Daytona Pinion Support
Ford 9", Grand National
This pinion support is cast from 30,000 psi gray iron and is far superior to the original Ford unit. Daytona supports have a larger rear (inner) bearing and race along with improved oil flow to the bearings. This allows for higher torque, horsepower, and longer bearing life. Pinion support weighs 6 lbs.
Bearings and races sold seperately.
Timken bearing and race numbers (for reference only):
- M88048 Front pinion bearing
- M88010 Front pinion race
- HM89443 Rear Daytona pinion bearing
- HM89410 Rear Daytona pinion race
Special pinion nut # 919-6885 is recommended to use in conjunction with this item.
More Like This
Speedway Cast Iron 9 Inch Ford Daytona Pinion Support
Aluminum 9 Inch Ford Daytona Pinion Support
Ring Gear Bolts for 9 Inch Ford, 10 PK
T-Bolt Kit w/ Nuts for Ford 9 Inch Rear End Housings
Ford 9 Inch Ring Gear Bolt Set
Differential Pinion Shaft Nut
Speedway 9 Inch Ford Rearend Axle Housing 3rd Member Carrier Studs
Pinion Nut for 9 Inch Ford
Speedway 9 Inch Ford Chromoly Cross Pin
3rd Member Mounting Hardware, 8/9 Inch Rearend
Q & A
Finally, Project Chevelle gets a real hot rod engine under its hood! And what about that flimsy old column shift three-speed? We've got that covered too.
Tim talks about our Winters quick change rear end & components.