Products to Compare (max of 3)
X
Compare These Parts
Talk to the Experts. Call 800.979.0122, 7am-10pm, everyday.
Customer Service
Since 1952
in
in
  • Expert Tech Support
  • Huge Inventory
  • Fast Shipping
Talk to the Experts. Call 800.979.0122
Shop By
Support
Account
Street Race Truck More... The Toolbox
Add to Cart
$39.99
$30.99
3X Chemistry Paint Stripper and Powder Coat Remover, Gallon
3X Chemistry Paint Stripper and Powder Coat Remover, Gallon

3X Chemistry Paint Stripper and Powder Coat Remover, Gallon

1.00 quarts Capacity

0 Reviews | 0 Answered Questions
In Stock
3X Chemistry Paint Stripper and Powder Coat Remover, Gallon
3X Chemistry Paint Stripper and Powder Coat Remover, Gallon
Zoomed In Image
Part # 30746820
Save 22%
$30.99
$39.99
gallon
Quantity:
Add to Cart
Call to Order
Add to Buildlist
Compare

Details
Reviews
Q&A
Articles

Important Messages:

  • This item ships via Ground Shipping only. Expedited and Air shipping options are not available.

Details

Capacity:
1.00 quarts
Sold in Quantity:
Each

Info

Simply spray or brush 3X: Chemistry Paint Stripper on and scrub the paint off with ease. Safe on factory fiberglass (will not affect Gel Coat), metal or wood. Non-acid formula contains a chemical seal to prevent evaporation of paint removing solvents, even in high-humidity. Most cars require 3-4 gallons for complete removal. Nonflammable.
  • Fast-acting
  • Removes paint and powder coat from most surfaces including; metal, factory fiberglass and wood
  • Gel based formula clings to all horizontal and vertical surfaces
  • Simply brush on and scrape the paint off with ease

30746820 Material Safety Data Sheet (PDF)

Notes

Application

Remove contaminants such as dirt and grease from the painted surface with a heavy duty detergent. Allow surface to air dry, as water will decrease the stripper's effectiveness. Pour 3X Paint Stripper into the metal container. DO NOT use a plastic container. DO NOT DILUTE. Working in approximately 2-3 foot sections at a time, generously spray 3X Paint Stripper so that the painted surface is wet, but not running or dripping. We recommend working from side to side, top to bottom. Allow to stand until paint is thoroughly wrinkled or bubbled. Using a scraper or spreader, check surface for complete penetration. If penetration is not complete, apply a second coat over the first and allow to stand for several minutes. Once penetration is confirmed, scrape off the lifted paint with a plastic scraper and dispose of in a metal container. Flush with water or solvent to rinse.

NOTE. Before priming, painting or using fillers on the bare surface, be sure to follow the coating manufacturer's surface preparation guidelines.

Some parts are not legal for use in California or other states with similar laws/regulations

Related Products

More Like This

Reviews

Q & A

Articles
  • Here is one method of stopping rust immediately, without replacing a single body panel. Click for more information on how to deal with rusty floor boards.
  • Maintain your classic's paint job with these 7 tips! Read this tech article to learn how to polish, preserve and protect your classic car's paint job.
  • Sprint car driver, McKenna Haase, learns her lesson the hard way and explains why she is so passionate about her helmet. She believes it is the most important piece of safety gear in racing, find out why!
  • A routine weekly maintenance checklist to perform between each race in order to keep a clean and efficient race car at the track.

You May Also Like

Suggestions
Error
Note
Ok