No items in Shopping Cart
This 16 gallon tank was designed to be bolted to the floor of a pick-up box, but we're sure you can figure out other applications. It measures 28" long, 10" deep and 16" tall. It accepts the common 240 ohm full - 33 ohm empty sending unit and the filler neck measures 1-1/2". Ports on this tank are 3/8" NPT for the pickup and 1/4" NPT for the vent.
This 11-gauge steel fuel tankincludes mounting tabs, vent tube, sender/pickup mount, fill tube and all mounting hardware. Tank has a 10.8 gallon capacity.
To make your LS1 transplant a little less painful, we put together these kits for you. If you already have a fuel pump in the tank, use the filter/regulator kit 910-12800. This kit includes a high pressure MSD in-line pump capable of 43 gph @ 40 psi or 39 gph @ 80 psi, a filter/regulator assembly, and all necessary fittings (including fuel rail fitting). Pump draws only 5.4 amps and supports up to 500 horsepower. Pump features 3/8" hose barb inlet and 5/16" barb outlet.
These spun aluminum tanks have an unpolished, spun aluminum finish, 2-1/4" neck, and a 1/4" NPT female outlet. For all off-road vehicles. The screw-on vented cap and brackets are included and can be found in a false bottom of the packaging box.
This fabricated aluminum fuel tank is built for our 1923 T-bucket kits with a 20" pick-up box. It features a raised fill neck w/ cap, AN-6 fuel pickup, and a rollover vent. Designed to be mounted to the left side which leaves room for your battery. Has a 10.4 gallon capacity.
2 Gallon added capacityAll new steel reproduction tanksIncludes: Original-style extra-length mounting straps & hardware, sending unit gasket, and fuel injecion block-off plate & gasketComes with flange for fuel injection pickup or use fuel line outlet for carbAccepts original or other after market sending units from Stewart Warner, VDO, Classic and others
Most modern engines have a hi-pressure fuel pump located in the gas tank. If you are transplanting one of these engines into your hot rod, what are you going to do for a fuel pump? This MSD pump can be mounted on the frame and can put out up to 43 gph at 40 psi or 39 gph at 80 psi.
This fabricated aluminum fuel tank is built for our 1923 T-bucket kits with a 20" pick-up box. It features a 240-33 ohm sending unit, flush mount fill neck, and AN6 fuel pickup, vent and return ports. Designed to be mounted to the left side which leaves room for your battery. Has a 14 gallon capacity.
Flush-mount caps offer excellent aerodynamic performance, large fill opening and attractive appearance. Cap features a positive seal, flip-up 1/4-turn handle, and a chain to secure it to the neck.Includes cap, chain, neck, gasket, and all hardware.Polyethylene cap is vented.Hole in tank needs to be 3-3/4" for cap to sit flush.