The pin-style quick-release steel hub is a tight 19 spline steel adaptor that welds to your steering shaft. Steel hub is retained by a steel quick release pin. Available for 3/4 or 5/8" shaft.
The pin-style quick-release aluminum hub has a weld-on splined inner steel shaft and steel pin. The tight 19 adaptor welds to steering shaft.
This push button quick-release features a billet aluminum hub and one-piece steel sleeve. No pins, just push the button to remove wheel from shaft. Purple anodized. Each includes a hub and weld-on sleeve for 5/8" O.D. steering shaft. Bolt holes for mounting steering wheel are 1/4"-20 fine thread.
This complete Grand National hub kit from Winters has a 5 on 5" bolt pattern and is made from cast 4140 heat treated steel to ensure that it holds up on your car. This hub kit fits 2-1/2" Grand National spindles and includes all needed hardware.Investment cast 4140 heat treated steel 24 spline steel drive flange Includes bearings races (installed) hub seal o-rings cap and screws lug nuts and studs 5 on 5" bolt pattern Fits 2-1/2” Grand National axle tube end Hub retaining nut not includedMFG. Part #2255C-9120Brake Rotor ...
On early Ford's the rear axles have a key way cut into the tapered end of the axle where a steel key is fitted the wheels lock onto this key and are then held onto the axle with a nut. Be sure to check your old keys worn keys can damage the keyway and therefore the axle. This is a 1928-48 Ford tight fitting rear axle hub key that will prevent damage to the axle key way. This key is tapered 1/4" on one side and 1/2" on the other ...
These quick release hubs come with a one-piece hex steel sleeve that must be welded to your steering column. Features a spring-loaded push button release. Purple anodized billet aluminum construction. Bolt holes for mounting steering wheel are fine thread 1/4"-20.
This push button quick-release features a billet aluminum hub and one-piece steel sleeve. No pins, just push the button to remove wheel from shaft. Purple anodized. Each includes a hub and weld-on sleeve for 3/4" O.D. steering shaft. Bolt holes for mounting steering wheel are 1/4"-20 fine thread.
These quick release hubs come with a one-piece hex steel sleeve that must be welded to your steering column. Features a spring-loaded push button release. Purple anodized billet aluminum construction. Bolt holes for mounting steering wheel are fine thread 1/4"-28.