1.50" O.D. .095" Wall 28" Long
1.50" O.D. .095" Wall 28 5/16" Long
1.50" O.D. .095" Wall 28" long
1.50" O.D..095" Wall28" Long
1.50" O.D..095" Wall28" long
Get your sprint car top wing mounted with this tubular Chromoly wing tree. The X-style design has slugs and pins for height adjustment and a bracket welded on for the wing slider cylinder. This is a tubular adjustable Chromoly rear wing tree for sprint cars. X-style design Sturdy Chromoly construction Has bracket welded on for wing slider cylinder Has slugs and pins to adjust height For mounting top wing on a sprint car 24" fully extended 18" collapsed Slugs go in 1" increments 26" mounting center for frame and wing ...
Factory replacement 4130 Chromoly tubes. 1-1/2" O.D. with .095" wall thickness.
Factory replacement 4130 Chromoly tubes. 1-1/2" O.D. with .120" wall thickness.
These precision CNC machined housings feature three o-rings on the outer side, and press securely into the axle tube of any GN housing. The unique design works with 28 or 31 spline GN axles to prevent rear end lube from filling the axle tube and depriving the ring and pinion of lubrication. Note: For Grand National rearends only.
DMI all aluminum constructed torque tube, 28" in length. Works with any rear end and for Sprint Cars only.
DMI all aluminum constructed torque tube 28" in length. Works with any rear end and for Sprint Cars only.
Get your sprint car top wing mounted with this tubular Chromoly wing tree. The X-style design has slugs and pins for height adjustment and a bracket welded on for the wing slider cylinder.This is a tubular adjustable Chromoly rear wing tree for sprint cars. X-style design Sturdy Chromoly construction Has bracket welded on for wing slider cylinder Has slugs and pins to adjust heightFor mounting top wing on a sprint car24" fully extended 18" collapsed Slugs go in 1" increments 26" mounting center for frame and wing3/4" O.D. tubing
This Sander Engineering midget torque tube and collar will fit most Midget Rear ends.
All Dynatech® headers are built with CNC laser-machined flanges. With port holes accurate to .003" and total warp less than .025" you can be assured that you will get all the performance and quality possible from your headers.For engines in the stock location or some setback. Clears mid engine mounts and stock clutch linkage. For straight or angle plug heads. Fits in stock location or with additional setbackClears AFCO/Howe style rear engine mountsGood ground clearanceFits angle or straight plug heads CNC laser-cut flangesConstructed to fit with proper clearanceOptimized tube length ...
Tubes required for our 8.20-15 or 8.90-16 grooved rear Firestone tires.