No items in Shopping Cart
Steel bracket attaches to axle with perch bolt. Plain steel finish.
Weld these brackets to the underside of your low-ridin' 'T' thru1934 Ford frame rails for a simple, strong place to attach 4-bars or radius rods. Plain steel.NOTE: For use with spherical rod ends.
91635015Overall Width3.500" (3 1/2")Overall Height7.000"Overall Thickness0.250" (1/4")Bolt Hole Pattern2.25 x 2.00Degree of Taper7 degreeMaterial TypeSteelFinishPaintedSold in QuantityPair
91635052Overall Width7.670"Overall Height4.138"Overall Thickness0.177"Inside Diameter0.619"Material TypeSteelFinishNaturalSold in QuantityPair
Weld-on brackets attach spring or radius rods to 2" O.D. axles.
This front radius rod is ideal for smaller or full-fendered cars. Rugged, 7/8" O.D. tubing is threaded 5/8" NF right hand at each end.These are designed to be used with bat wings or axle brackets with a 5" center to center bolt hole spacing on front tube or I-beam axles only. Not to be used for rear suspensions. Before installing the heim joints or clevis ends, the actual measurement will be center to center 4-1/2". The angle of the tube will increase the measurement to 5" after installing the end ...
These front radius rodsare ideal for smaller or full-fendered cars. Rugged, 7/8" O.D. steel tubing is threaded 5/8"-18 NF right hand at each end.
These front radius rodsare ideal for smaller or full-fendered cars. Rugged, 7/8" O.D. chrome plated steel tubing is threaded 5/8"-18 NF right hand at each end.
These front radius rodsare ideal for smaller or full-fendered cars. Rugged, 7/8" O.D.polished stainless steeltubing is threaded 5/8"-18 NF right hand at each end.
These front radius rodsare ideal for smaller or full-fendered cars. Rugged, 7/8" O.D. brushed stainless steel tubing is threaded 5/8"-18 NF right hand at each end.
Speedways Radius Rod Tube axle kits are designed to fit '28-'31 Model Aand '32-'34 Fordframes. These tube axles require'37-'48Ford passenger car spindles. Kits are available in Plain steelor Chrome.
Titanium Radius Rod Kit, 19 Piece.
Speedway Radius Rod I-Beam axle kits are designed to fit '28-'31 Model Aand '32-'34 Fordframes. I-Beam axles require'37-'48Ford passenger car spindles. Kits are available in plain steel.
3008005Overall Length32.000"Sold in QuantityEachNotesUsed for determining the length needed for tie rods, drag links, radius rods, etc. Works in 1/2" 5/8" and 3/4" rod ends.
Simple tool for setting tie rod and radius rod lengths. Fits 1/2", 5/8" and 3/4" rod ends.
Swedged aluminum steering panhard and radius rods that are 3/4" x .120 round 6061-T6 and tapped for 7/16"-20 threadrod ends. Stocked in several lengths.