No items in Shopping Cart
Jack Roush Racing designed these high density cast iron heads to be the most powerful head for 5.0 Fords. When it comes to high performance replacements for factory cast iron heads, World's WINDSOR SR. boasts 200cc ports and64cc exhausts ports, whichflow asubstantially larger volume of air than any OEM Ford head. Add a highly efficient combustion chamber design and larger valves, and you have big bolt-on power! These heads are also 50-State emissions legal factory replacements.
By George Reid. Covers big and small block Ford. Includes factory high performance parts and interchangeability between Windsor and Cleveland engines. 158 pages.
Edelbrock's Performer RPM 351W is designed for 1969 and later 351 Windsor Ford V8 high-performance engines with Edelbrock Performer RPM cylinder heads, modified OEM cylinder heads or equivalent. The dual-plane design offers good throttle response with excellent top-end power for the street. Has a 1500-6500 rpm power band.
The Edelbrock Victor Series intake manifolds have set the standard for quality and performance in the racing industry. The Victor Jr. 302 is designed for Ford 260-289-302 competition engines using modified stock cast iron or aftermarket Windsor-style cylinder heads.
Victor series intake manifolds set the standard for quality and performance in the racing industry. Edelbrock's Victor Jr. 351-W is designed for 1969-Up 351 Windsor V8s using stock 12 or 16 bolt heads, and similar aftermarket heads. Fits standard 351W blocks with 9.50" deck height (not SVO).
Build a mock Boss 351 engine with a standard 351W block and 351 Cleveland heads using this Performer RPM E-Boss 351 manifold. For both high performance street and competition, the dual-plane design makes outstanding power from 1500 to 6500 rpm and the Cleveland port layout and intake bolt hole pattern fit both 2V and 4V heads. It features 9.5" deck height, Windsor end rails, water neck and distributor hole clearance, front and rear water bosses with a standard square bore carburetor pad.
This book addresses high-performance V-8 engines such as the 289, 302, 351ci small-blocks found in Mustangs, as well as the FE series of big-blocks. Emphasis throughout is a budget approach to building high performance powerplants through the use of over-the-counter factory components and selected aftermarket pieces. Includes realistic, low-cost formulas for building serious horsepower in Ford V-8 engines. 128 pages.
Give your FE-powered hot rod dual-quad power and nostalgic looks with the new Edelbrock RPM Air-Gap Dual-Quad intake manifold. Designed for 1960-later high-performance street 390-406-410- 427-428 c.i.d. Ford FE engines with a 1500-6500 rpm power band. The manifold carb pad is setup to fit Edelbrock carburetors only, will not work with other square flange carburetors. Will not fit 427 Ford Hi-riser and Tunnel port engines. Has provision for a breather flange at rear. Carb center spacing 6-7/16"
COMP Cams Pro Magnum Hydraulic Lifters are specifically designed to perform at higher engine speeds. When engines are equipped with a hydraulic lifter, high rpm is limited by the improper position of the internal piston as the lifter inevitably "pumps up". This improper location results in open valves and therefore leads to lost power or sometimes even engine failure. COMP Cams Pro Magnum Hydraulic Lifters offer a distinct advantage over standard high performance hydraulic lifters, especially in race applications where a hydraulic lifter must be used.