Info
Stock clutch hydraulic throwout bearing for stock style Chevy clutches only. Install simply by replacing one bolt from the front of the transmission with one of the provided studs, then shim to fit. Use 3/4" master cylinder.
This bearing is made much smaller than the racing version so that it will fit behind the "thicker" stock style clutches. This new design is much cleaner. It has no boss on the body.
AN4 fittings on the feed and the bleed line. Both fittings are tapped inside to accept the bleeder fitting. If you would like an external bleeder, purchase one each of the following: 8352200063, 6174025 and 91031842-4.
This new design also has a retainer on it to prevent over extension and seal damage.
91025611
WARNING-THIS SEAL KIT WORKS WITH THROWOUT BEARINGS PURCHASED PRIOR TO JANUARY 2007.
910-25610 Instructions (pdf)
Application
910-25610 Bearing typically used with:
- Jerico 2-speeds
- Saginaw 3-speeds
- Muncie 4-speeds
- Saginaw 4-speeds
- B-W 4-speeds
- Jerico 4-speeds
- Works with most stock type clutches
910-25610 Bearing will NOT work with:
- B-W T-5 transmission without alteration of the nose cone. Howe has a separate number for the T-5 transmission, but neither will work with the Ford type T-5.
- Ram coupler
- may not work with racing style clutches because of limited extension on our hydraulic throw out bearings. The extension on our 910-25610 is .789" of travel.
910-25612
- This hydraulic clutch release bearing is designed to be used with GM base T-5 five speed transmissions. NOT Ford.