These beautiful replacement '26-'27 Model T windshield frames are available as a complete frame kit or just the bottom section to fit a specific application. These are 7/8" O.D. and the glass channel is 5/16" wide and 1/4" deep. The lower part of the frame next to the body accepts our T seal number 555-92600 and the slot for the seal is 1/8" wide with provision to accept the "T" style seal. No glass or windshield rubber included with our frames. The slugs that are included with this windshield frame must be ...
Mr. Roadsters 2-piece round top windshield frames fit most fiberglass T-buckets. Triple chrome plated. Kit includes frame (approximately 20" tall) and hardware. Designed for short style windshield posts. No glass or windshield rubber is included with our windshield frames. Note: Speedway's 1923-25 T bodies use a 39-5/8" wide windshield frame when using short posts. Builder's Tip: If using 1/4" glass or lexan, use urethane or setting tape (available from a glass shop) and do not use brass setting channel.
Mr. Roadster '09-'12 Model T windshield frames are constructed from solid brass, then fully polished. Features a brass channel. No glass or windshield rubber is included with these windshield frames. Builder's Tip: If using 3/16" glass or lexan, use with a brass setting channel. If using 1/4" glass or lexan, use urethane or setting tape (available from a glass shop) and do not use a brass setting channel.
Windshield frame hinges for 1909-22 Model T Ford Roadster windshields. NOTE: Functional hinges have a mounting stud for windshield support rods. Functional hinges only pivot/function when the pivot assembly is forward or to the front of the windshield frame. These become a non-functional 2-piece design when the pivot assembly is installed to the rear or behind the windshield frame. 911-56400 Instructions (PDF)
Polished stainless steel windshield frame hinges for 1909-22 Model T Ford Roadster windshields. NOTE: Functional hinges have a mounting stud for windshield support rods. Functional hinges only pivot/function when the pivot assembly is forward or to the front of the windshield frame. These become a non-functional 2-piece design when the pivot assembly is installed to the rear or behind the windshield frame. 911-13104 Instructions (PDF)