No items in Shopping Cart
Rear license plate bracket for your1932 Ford. Available in black or stainless steel.
Use these rear axle mounting brackets to attach any late model rear end to your 1935-1948 Ford frame. Use a 1935-1948 spring and your stock crossmember. Includes 2-1/4" shackles, weld-on brackets and instructions.
1933-1936 Fordrear license plate bracket. Available in black or stainless steel.
"Forward mount" design provides increased pull bar angle and forward bit during axle wrap-up and chassis lift over conventional mounting positions centered on axle-8 degree pinion angle allows torque link to be mounted 4" ahead and 12" above axle centerline Forward mounting reduces axle wrap-up from 25-33 percent, which provides consistent corner entry handling during axle wrap-down and improves U-joint life.Multiple holes for mounting torque link and dampener shock3/8" holes allow stiffener braces to be added on high horsepower applicationsLaser cut design fits most rear ends. (Some ...
Mounts a late model rear into a T-1931 Ford chassis when using a high-arch 2-1/4" wide spring (like 910-43102). Locates spring directly above the axle housing. Includes zinc plated shackles with nylon bushings, weld-on brackets, and instructions.
1933-1936 Ford license plate brackets. Front and rear bracket available in black or stainless steel.
This 9" Ford panhard bar mounting bracket has several settings so you can adjust roll center to multiple positions. IMCA approved steel construction. Fits 9" Ford rear ends only.
US Brake weld-on brackets for GM single-piston iron calipers. Fits 3" axle tubes.
Use to mount GM lower arms to your rear end. Designed for 3" O.D. axle.
Mounts 1969-1977 GM mid-size car front caliper to any 3" tube rear end using 11-3/4" diameter rotors. Fully machined steelwith punched lightening holes. Measures approximately 7" between mounting holes.
Mounts 1978-1988 GM front caliper to any 3" tube rear end using 11-3/4" diameter rotors. Fully machined steelwith punched lightening holes. Measures approximately 5-1/2" between mounting holes.
Bracket fastens on rear axle and mounts coil-overs so that axle wrap tends to load or unload tires closest to clamps. For 3" axle tubes.
These behind rear end panhard bar brackets have four 3/4" holes for changing roll center and panhard bar angle. Fits 3" axle tube. Weld-on.
All brackets are for 3" rear axle application.
All brackets are for 3" rear axle application.Low Rear Axle BracketMount radius rods lower than rear axle. 3/8" steel. 5-3/4" long. 3/8" holes.