No items in Shopping Cart
Use these rear axle mounting brackets to attach any late model rear end to your 1935-1948 Ford frame. Use a 1935-1948 spring and your stock crossmember. Includes 2-1/4" shackles, weld-on brackets and instructions.
Weld these brackets to the underside of your low-ridin' 'T' thru1934 Ford frame rails for a simple, strong place to attach 4-bars or radius rods. Plain steel.NOTE: For use with spherical rod ends.
Mounts a late model rear into a T-1931 Ford chassis when using a high-arch 2-1/4" wide spring (like 910-43102). Locates spring directly above the axle housing. Includes zinc plated shackles with nylon bushings, weld-on brackets, and instructions.
"Forward mount" design provides increased pull bar angle and forward bit during axle wrap-up and chassis lift over conventional mounting positions centered on axle-8 degree pinion angle allows torque link to be mounted 4" ahead and 12" above axle centerline Forward mounting reduces axle wrap-up from 25-33 percent, which provides consistent corner entry handling during axle wrap-down and improves U-joint life.Multiple holes for mounting torque link and dampener shock3/8" holes allow stiffener braces to be added on high horsepower applicationsLaser cut design fits most rear ends. (Some ...
This 9" Ford panhard bar mounting bracket has several settings so you can adjust roll center to multiple positions. IMCA approved steel construction. Fits 9" Ford rear ends only.
NOTE: Right hand has a hole for mounting a rumble step.
A nice compliment to a 4-bar front suspension on a 1928-34 Ford, is a 1968-73 Mustang steering box used in a "traditional steering" set-up. This bracket welds to the backside of the driver's side bracket which holds the 4-bars onto the chassis. The Mustang box's pitman arm points up and the drag link is parallel to the left side 4-bars.
Headlight mounting bracket features a tapered aerodynamic design. Has an internal hole for hidden wire. Measures8" tall. Plain, as-cast finish.
Headlight mounting bracket features a tapered aerodynamic design. Has an internal hole for hidden wire. Measures8" tall.Fully polishedfinish.
473800Overall Height9.125" (9 1/8")Overall Width1.250" (1 1/4")Inside Diameter8.000"Centerline of Holes4.250" (4 1/4")FinishPowder CoatColorBlackMaterial TypeSteelSold in QuantityPair
These universal aluminum bomber seat mounting brackets allow approximately 6" of adjustment. No mounting holes drilled due to unlimited combinations. Fabrication required.