No items in Shopping Cart
Adapt your 1949-1953 Ford Flathead V8 engine to a modern Ford AOD automatic overdrive transmission so you can keep those stump-pulling low rear end gears, while still maintaining engine life and gas mileage. Plus, the lightweight flexplate and torque converter do wonders for throttle response and stop-and-go driving!
Adapt your 1949-1953 Ford Flathead V8 engine to a modern Ford automatic transmission. This complete transmission conversion kit is an excellent upgrade for early Ford drivetrains - the lightweight flexplate and torque converter does wonders for a Flathead's throttle response and stop-and-go driving. This kit includes Speedway's Street King Ford transmission completely remanufactured with heavy duty clutches, special shift kit, torque converter, engine adapter, special flexplate, modified 12-volt starter, hardware, and instructions.
Powermaster's MasterTorque Series gear reduction starters have a 1.4 Kw motor that cranks out 180 ft.-lbs. of torque. Fits Small Block Ford 289-302-351 with an automatic transmission or 5-speed manual transmission. Also works well with Speedway Flathead-to-C4 Automatic Conversion (910-28906).
Powermaster XS Torque gear reduction starters are built using all new components and cranks out 200 ft./lbs. of torque. It bolts up like an original starter, but its gear-reduction design gives it more power to crank over high-compression engines. Fits USA-made 1932-1953 flathead Ford V8 engines using manual transmissions & steel flywheels.
Speedway has you covered if you need a "stump puller" starter for your Flathead Ford V8. Our gear reduction starter is built using all new components and cranks out 200 ft./lbs. of torque. It bolts to the original mounting points on 1932-1953 engines with manual trannys & steel flywheels.
If you have access to your own transmission and parts or you wish to adapt an AOD or C4/C6, this basic adapter set is what you need. Includes: starter nose cone, flexplate, bellhousing adapter and instructions. Choice of 157 or 164 flexplate. Use with 302-351W transmission.
For 1932-1953 early & late Flathead V8 engines. Weighs 12 lbs. For use with "Long" style pressure plate (10.5" or 11" diameter) or "Diaphragm/Borg Beck" style pressure plate (10.5" diameter). Must use a non-metallic, 100%organic clutch disc. Accepts either the stock starter or our 910-67475 starter.
These lightweight setup blocks are made of closed-cell polyurethane molded directly from original castings. These blocks are great for mocking up engine mounts in a chassis, and you can even bolt up all of your accessories to check for fit and clearance.
Edelbrock now offers their 1938-1948 Ford/Mercury 24-Stud Flathead cylinder heads with the traditional block letters Vic Sr. used. Extensive R&D and modern CAD systems give these heads more power potential and greater heat control than any before! Works well on stock or modified engines.
This flathead fuel pump block off is used when removing the original fuel pump. Works on 1942-48 Ford/Mercury V8's.