No items in Shopping Cart
The Edelbrock Victor Series intake manifolds have set the standard for quality and performance in the racing industry. The Victor Jr. 302 is designed for Ford 260-289-302 competition engines using modified stock cast iron or aftermarket Windsor-style cylinder heads.
Give your FE-powered hot rod dual-quad power and nostalgic looks with the new Edelbrock RPM Air-Gap Dual-Quad intake manifold. Designed for 1960-later high-performance street 390-406-410- 427-428 c.i.d. Ford FE engines with a 1500-6500 rpm power band. The manifold carb pad is setup to fit Edelbrock carburetors only, will not work with other square flange carburetors. Will not fit 427 Ford Hi-riser and Tunnel port engines. Has provision for a breather flange at rear. Carb center spacing 6-7/16"
Designed for Ford and Mercury engines made from 1938 to 1948. Heat crossover is blocked off. 10-5/16" carb centers.
Edelbrock's Performer RPM 351W is designed for 1969 and later 351 Windsor Ford V8 high-performance engines with Edelbrock Performer RPM cylinder heads, modified OEM cylinder heads or equivalent. The dual-plane design offers good throttle response with excellent top-end power for the street. Has a 1500-6500 rpm power band.
These reproductions of the vintage Edelbrock manifold #SU 359 and #SU 349 allow the use of three 2-barrel carbs on a 1938-1948 and 1949-1953 Ford Flathead engines.
Edelbrock now offers their 1938-1948 Ford/Mercury 24-Stud Flathead cylinder heads with the traditional block letters Vic Sr. used. Extensive R&D and modern CAD systems give these heads more power potential and greater heat control than any before! Works well on stock or modified engines.
For 1932-1953 early & late Flathead V8 engines. Weighs 12 lbs. For use with "Long" style pressure plate (10.5" or 11" diameter) or "Diaphragm/Borg Beck" style pressure plate (10.5" diameter). Must use a non-metallic, 100%organic clutch disc. Accepts either the stock starter or our 910-67475 starter.
This book by Joe Abbin will show you 'real' horsepower figures from 'real' Flathead Ford engines that were built and run on the dyno, the street and the dragstrip. Clearly shows each engine (naturally aspirated and supercharged) being built and dyno tested. 138 pages.
If you're going to overhaul your Flathead, you're going to need new gaskets. This complete overhaul gasket set is for 1949-1953 Ford and Mercury flathead V8 engines.Includes all the necessary gaskets and seals you need for a typical engine rebuild.
For 1932-1953 early and late style Flathead V8 engines. Weighs 12 lbs. For use with "Long" style pressure plate (10.5" or 11" diameter) or "Diaphragm/Borg Beck" style pressure plate (10.5" diameter). Must use a non-metallic, 100%organic clutch disc.