No items in Shopping Cart
Power steering pump pulleys for a long water pump available in plain, polished, or chrome. Pulley listed is 5-3/4" in diameter.
We offer this Saginaw power steering pump with a new reservoir, billet cap, chrome hardware and new dipstick. Desirable early style 1965-79 pump with threaded and keyed shaft for easy pulley installation. Available in chrome. Hoses available from local parts stores.
Aluminum Pump Installation Instructions(PDF)
Cast Iron Pump Tech(PDF)
KRC now has its power steering pumps available with a billet aluminum reservoir attached, rather than remote.
These components would cost over $360.00 if purchased separately!Cast Iron Pump Tech(PDF)
So, you've converted over to a 12-volt electrical system and bolted a GM alternator to your Flathead. Now it's time to install the belt and pulley, but your engine uses a 5/8" belt and the alternator pulley is 1/2"!
So you've converted your Flathead-powered rod over to 12 volts and bolted a GM alternator in place. Now it's time to install the belt, but your engine pulley is 5/8" and the alternator is 1/2"!
This pulley fits GM alternators and allows you to mount a vintage '32-'38 Ford fan to it. This Pulley uses 5/8" wide belt.
The Silver Bullet alternators are 100% new construction with a distinctive billet fan and pulley for good looks and increased performance. They are a one-wire hook-up with ultra low cut-in regulator which charges from a idle up to highway speeds.
The Silver Bullet alternators are 100% new construction with a distinctive billet fan and pulley for good looks and increased performance. They are a one-wire hook-up with ulatra low cut-in regulator which charges from a idle up to highway speeds.