Tight-Tubes Block Hugger Header Extension Kit, Mild Steel
Click image to enlarge
Please note the following about this product:
- This item is sold as a pair.
Q & A (7)
What's in the Box
Using this kit makes the hook-up of your exhaust system a snap! The 2-1/2" diameter, 16-gauge, mandrel-bent tubes curve back at a 90° angle and are offset outward to clear the bellhousing and starter. They drop 10-1/2" from the header flange and they extend backward 17-1/2" after the 90 degree bend.
Just trim the length, weld on the 9/32" thick collector flange (included, with gaskets) and you're all set! Works great with any tight-fit headers. Header not included.
You may also be interested in:
Collector Gasket - 2 1/2 Inch Inside DiameterView$0.99Compare