Since 1952
America's Oldest Speed Shop ®
Speedway Motors Bill Smith
Large Image
CLOSE [X]

Sweet Mfg Steering U-Joint, 3/4-30 Spline to 3/4 Round, Small GM P/S 1978-Up

Price:
$49.99
EA
In Stock
Item #:
91032238
Item Details:
Small GM P/S,'78 and Later
3/4"-30 Spline
Finish: PLN
Sweet Mfg Steering U-Joint, 3/4-30 Spline to 3/4 Round, Small GM P/S 1978-Up
Click image to enlarge Click image to enlarge
No video at this time.
 

Don't jeopardize your safety with inferior quality steering components. Speedway offers only the finest steering U-joints available. Made by Sweet Manufacturing. These steering universal joints have a 3/4" round weld-on end.

  • Full compliment bearings
  • Forged Vanadium steel yokes and u-joint
  • Highest quality for racing or street
  • Features needle bearing u-joints
  • 3/4"-30 Spline

Steering U-Joints and Couplers Application Chart (GIF)

Steering Box/Rack/Spline Chart (Link)

Spline Size (Link)

Note: GM columns measure slightly less than 1" while IDIDIT and Flaming River columns measure a true 1".  DO NOT interchange these u-joints.

When purchasing U-Joints, 3 easy steps will help ensure that they will be correct for your application.

STEP 1
Be sure to measure the diameter of the shaft and count the number of splines on the shaft. Some shafts have a blank spot ground on one side. To get the correct number of splines, use a flat edge and cover the blank half of the shaft through the diameter and count the splines on the other half. Multiply that number by 2, thus giving you the total number of splines on the full circumference of the shaft.

STEP 2

Choose which shaft type best suits your application: 3/4" weld on, 3/4" DD or 1" DD.

STEP 3
With these two pieces of information at hand, refer to our chart to find the appropriate part number of the ujoint for your specific application.

Tech Tip #1: When using more than two universal joints in a system, a support heim must be used.

Tech Tip #2: Increasing a U-Joint's angle of operation beyond 30° dramatically increases the stress on the joint, weakening the whole steering mechanism. If a greater angle is needed, add another u-joint.

Email this page
Close [x]
You can send this product by email to a friend!
Enter the required information in the spaces provided below. They will receive an Email with the picture of this product and a link back to our site.
Your Name:
Your Email:
Friends Name:
Friends Email:
Print Page
Our Techs also Suggest the Following:
Steel Heim for Steering Shaft, 3/4-16 RH Male, .757 Hole
Price:
$9.99
EA
In Stock
Item #:
1750757
Item Details:
.757" Ball Hole
Firewall Mount Flanged Bearing for Steering Shaft
Item #:
91032375
You May Also Be Interested In...