Sweet Mfg U-Joint, 1 In DD, 3/4 Round, IDIDIT/Flaming River Column
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
Dont jeopardize your safety with inferior quality steering components. Speedway offers only the finest steering U-joints available. Made by Sweet Manufacturing. These steering universal joints have a 3/4" round weld-on end.
- Full compliment bearings
- Forged Vanadium steel yokes and u-joint
- Highest quality for racing or street
- Features needle bearing u-joints
Note: GM columns measure slightly less than 1" while IDIDIT and Flaming River columns measure a true 1". DO NOT interchange these u-joints.
Item DetailsGM columns measure slightly less than 1" while Ididit and Flaming River columns measure a true 1".
ApplicationWhen purchasing U-Joints, 3 easy steps will help ensure that they will be correct for your application.
Be sure to measure the diameter of the shaft and count the number of splines on the shaft. Some shafts have a blank spot ground on one side. To get the correct number of splines, use a flat edge and cover the blank half of the shaft through the diameter and count the splines on the other half. Multiply that number by 2, thus giving you the total number of splines on the full circumference of the shaft.
Choose which shaft type best suits your application: 3/4" weld on, 3/4" DD or 1" DD.
With these two pieces of information at hand, refer to our chart to find the appropriate part number of the ujoint for your specific application.
Tech Tip #1: When using more than two universal joints in a system, a support heim must be used.
Tech Tip #2: Increasing a U-Joint's angle of operation beyond 30° dramatically increases the stress on the joint, weakening the whole steering mechanism. If a greater angle is needed, add another u-joint.
The 1” double D end fits the bottom of most of the Ididit steering columns. The opposite end of the u-joint fits a piece of ¾” diameter round shaft. The end going to the ¾” round shaft is typically welded to the shaft or cross-drilled and pinned with a couple of roll pins.
More Like This
Sweet Mfg U-Joint, 3/4 In Round to 1 In DD, GM Column/Universal
Sweet Mfg U-Joint, 1 In DD to 1 In DD, IDIDIT/Flaming River Column
Sweet Mfg Steering U-Joint, 13/16-36 Spline to 1In DD, Big GM Pre 1978
Sweet Mfg U-Joint, 5/8-36 Spline, GM 1 In DD, Vega/Corvair/GM Rack
Sweet Mfg U-Joint, 3/4 36-Spline to 1 In DD, GM Manual/Mustang II
Sweet Mfg U-Joint, 9/16 26 Spline to 1 In DD, Mustang II Manual
Sweet Mfg U-Joint, 3/4-30 Spline to 1 In DD, Small GM P/S 1978-Up
Sweet Mfg Steering U-Joint, 3/4-48 Spline to 1 Inch DD, Wilwood/SJ/MGB
Sweet Mfg. Steering U-Joint, 1 Inch 48-Spline to 1 Inch DD, GM Column
Sweet Mfg. Double Steering U-Joint, 1 Inch DD to 3/4 Inch Round
Q & A
Nice graphic courtesy of Bills Hot Rod Company about which of thier Power Steering brackets will work with which water pumps, on both small block and big block Chevy engines.