Unisteer 8050420 Steering U-Joint, 3/4 Inch Smooth to 3/4 Inch Smooth
Click image to enlarge
Q & A (1)
What's in the Box
These polished stainless steel U-joints look & function beautifully and use non-pinch bolts which will need to be either welded, cross-drilled and pinned or bolted. These steering universal joints are 3-3/4 inch in total length and have a 1.650 inch diameter.
- The OD is 1.650" (41.90mm)
- 3-3/4" in total length
Item DetailsStainless Steel
Not a pinch bolt style u-joint
ApplicationWhen purchasing U-Joints, 3 easy steps will help ensure that they will be correct for your application.
Be sure to measure the diameter of the shaft and count the number of splines on the shaft. Some shafts have a blank spot ground on one side. To get the correct number of splines, use a flat edge and cover the blank half of the shaft through the diameter and count the splines on the other half. Multiply that number by 2, thus giving you the total number of splines on the full circumference of the shaft.
Choose which shaft type best suits your application: 3/4" weld on, 3/4" DD or 1" DD.
With these two pieces of information at hand, refer to our chart to find the appropriate part number of the ujoint for your specific application.
Tech Tip #1: When using more than two universal joints in a system, a support heim must be used.
Tech Tip #2: Increasing a U-Joint's angle of operation beyond 30° dramatically increases the stress on the joint, weakening the whole steering mechanism. If a greater angle is needed, add another u-joint.
You may also be interested in:
U-Joint, 3/4"-36 Spline To 3/4" Round Weld-onView$49.99Compare
Polished Stainless Steel 3/4 O.D. Double D ShaftView$79.99Compare