Since 1952
America's Oldest Speed Shop ®
Speedway Motors Bill Smith

Small Block Ford 302-351W Electric Water Pumps

SAME DAY SHIPPING!

Specs
Overall Width:
8.50
Weight:
6.30
Sold in Quantity:
Each
Finish:
Powder Coated
Mounted Length:
6.75
Hose ID:
1.75
Gasket(s) Included:
Yes
Hardware Included:
Yes
Notes
Clearance from back of pump to engine block mount plate is 1.19"

Share by Email

From
To

Click image to enlarge

X

Details

Reviews

Q & A

What's in the Box

Small Block Ford Electric Racing Water Pumps feature a specially machined housing to maximize flow. The lightweight aluminum assembly is flow-rated at 35+ gallons per minute and weighs less than 6 lbs. Pump draws 6-7 amps.

  • Joints feature “O” ring gaskets for a perfect seal
  • Black powdercoat finish
  • Includes mounting hardware and wiring pig tail
  • Length of aluminum inlet 3.375" (.75" of which is threaded 3/4")
  • Plate mount center to center: 2.00"
  • From pump bottom to mounting surface: 1.50"
  • From top of outlet shoulder to mounting surface: 3.25"
  • Diameter of the pump: 4.00"
  • Length outside to outside shoulders: 10.125"
  • 10.00" of wiring off the pump, 5.00" off pigtail
  • Plate thickness .15"

Water Pump Rebate (PDF)

Specs


You may also be interested in:

S/B Ford High Performance Short Water Pump
                        Each aluminum pump is manufactured from T6 aluminum and features a revised impeller entry with curved vanes for maximum flow, pressure and equal distribution to both sides of the block. It also features a unique seal assembly for leak proof operation. 

Includes a heavy duty bearing and 3/4" shaft and pulley snout; and 1/2" NPT hole on the passenger side (for heater hose) and on the top (for by-pass hose). Thicker (0.100") stamped steel rear plate. Weighs 6 lbs.

 

910-155 Instructions (PDF)

Stewart Components 36114 S/B Ford SVO Stage 3 Water Pump, 5.45 Inch
                        

These pumps are assembled with 356-T6 heat treated aluminum castings. Precision CNC machined components. The fan hubs are 1/2" thick and machined from billet steel. These pumps are preferred by many top engine builders for higher RPM applications.

  • Fan hub has a dual pattern for 1-1/4" and 1-1/2" center to center fan mounting patterns
  • Pump measures 5.581" from mounting point on block to front of hub flange
  • To end of the hub snout is an additional .710" for an overall length of 6.291"
These stage 3 water pumps feature 1/2" thick steel fan hub with set screw for positive positioning and 356-T6 heat treated aluminum casting. There is higher flow and pressure for better cooling as well as equal flow to right and left cylinder heads.  The 3/4" bearings offer 5 times the strength of standard bearings.  Precision impeller installed to exacting tolerances.  One year manufacturers warranty.

High Performance Water Pump Installation Instructions (pdf)