Coilover Mockup Tools
- Allows simulation of vehicle ride height for fabrication purposes
- Include 5/8" rod ends, jam nuts, quick pin, and reducer for rod ends from 5/8" to 1/2"
Builders Tip: If you cut a short piece of roll bar padding shown below and install it around the coil over mock up assembly, the o/d of the roll bar padding will replicate the o/d of the coil over spring to be used. This will allow the builder to visualize and consider where and how it needs to be mounted for clearances as if the coil over springs were in place.
When youre building your car, its hard to set ride height if you dont have the engine and body installed. This handy tool allows you to simulate the installed length of your coil-overs, which will give you a finished ride height. The coil-over shock setup tool is for fabrication purposes only, not built to replace shocks. It fits 1/2" or 5/8" coil-over mounts. Available as 9" thru 17" minimum installed length. Adjustment of at least 1" longer is possible.
Item DetailsNote: Lengths provided are eye to eye or installed working length.
These adjustable mockup kits are great for determining the desired ride height for Mustang II crossmember and front end assemblies. They are easy to use and will give you the exact measurements you will need for final assembly.
- Use to determine ride height with MII installations
- Adjustable up to 3"
- Make you next mockup easy and exact