Bill Smith
Founder, 1929-2014
Speedy Bill
Since 1952
Speedway Motors Logo
America's Oldest Speed Shop ®


Round Weld-On Shock Eye Mount for Tie-Rod Shock

Material Type:
Sold in Quantity:
Overall Thickness:
Black Oxide
Outside Diameter:
Degree of Taper:
7 degree
Top of Taper:
Bottom of Taper:
Garage Sale:
This is intended only to be used w/ the monroe shock tie rod mounts or stud kit 535AK35. If Ford tie rod ends are considered, use 91636503 (triangular).
Round Weld-On Shock Eye Mount for Tie-Rod Shock

Click image to enlarge



Q & A

What's in the Box

Round shock eye for use with Monroe tie rod conversion kit. Eye has a 7° inner taper. 

You may also be interested in:

Weld-On Shock Eye For Tie-Rod Shocks, Triangular
(Part #91636503)

Weld-on 5/8" diameter tapered hole. Required for mounting early Ford 1937-48 tie rod ends. Hole has a 7° taper. Center of shock hole is 7/8" from base.

This item will accept tie rod end kit 535-AK35 and also 916-36055-PINTO tie rod adapter stud.

Speedway Tapered Ball Joint Reamer, 7 Degree
(Part #91089411)

Tapered reamers for proper fitting of ball joints to spindles, tie rod ends to spindles, etc. These have 1/2" shank. The 1-1/2" per foot reamer, also known as a 7° tapered reamer, works with Speedway ball joints 917-20031 K6024, 917-20032 K6136, and 910-34323 K772.

Measures a little less than 1/2" at the small end and 1" at the big end.

Monroe Tie Rod Conversion Kit
(Part #535AK35)
Converts any 1/2" bearing end shocks to tie rod end. 7° taper. Adapter studs are threaded 1/2"-20 on each end with an overall length of 3-1/4". One end has a 7° tapered pin, the other end is 1/2" dia.