For use on the secondary carbs in a tri-power three deuce setup. Fits small base Rochester 2G and 2GC carbs from the mid '50s through approximately 1968 with throttle bore centers of 1.6".
Two throttle plates required per carburetor. Screws NOT included (sold separately with extended throttle shafts).
Caburetor Stud Kit, 1 3/8" Easy installation/removal of carb plates. Includes zinc plated steel studs, nuts and washers.
Caburetor Stud Kit, 1 3/8"
Easy installation/removal of carb plates. Includes zinc plated steel studs, nuts and washers.
Many applications use a ball on the carburetor arm to hook the linkage to. This handy little assortment of 4 throttle balls with various threads will allow you to finish up linkage.Includes
Many applications use a ball on the carburetor arm to hook the linkage to. This handy little assortment of 4 throttle balls with various threads will allow you to finish up linkage.
Includes
For use on the primary (center) carb in a Tri Power setup. Fits small base Rochester 2G and 2GC carbs from the mid '50s through approximately 1968 with throttle bore centers of 1.6".Two throttle plates required per carburetor. Screws NOT included (sold separately with extended throttle shafts).
For use on the primary (center) carb in a Tri Power setup. Fits small base Rochester 2G and 2GC carbs from the mid '50s through approximately 1968 with throttle bore centers of 1.6".
Extended throttle shaft for Rochester 2G or 2GC carbs. For use in primary carbs in tri-power three deuce setups with progressive linkage. Fits "small base" Rochester 2 barrel carburetors w/ 1.6" throttle bore centers used on 1950's thru approximately 1968 GM cars.Use with factory throttle plates or aftermarket plates.
Extended throttle shaft for Rochester 2G or 2GC carbs. For use in primary carbs in tri-power three deuce setups with progressive linkage. Fits "small base" Rochester 2 barrel carburetors w/ 1.6" throttle bore centers used on 1950's thru approximately 1968 GM cars.
Use with factory throttle plates or aftermarket plates.
Designed for Rochester Tri-Power. Kit includes stainless steel throttle cable bracket and stainless steel springs. Stainless bracket mounts under rear carburetor on Rochester 3-2 set-up. Cables operate from center carburetor. Stainless bracket and dual stainless springs are used to mount Lokar's throttle cable and kickdown assemblies.