Since 1952
America's Oldest Speed Shop ®
Speedway Motors Bill Smith

Rear Axle Breather

SAME DAY SHIPPING!

Specs
Material Type:
Aluminum
Sold in Quantity:
Each
Finish:
Polished
Thread Length:
.25
Body Length:
1.00
Garage Sale:
No

Share by Email

From
To

Click image to enlarge

X

Details

Reviews

Q & A

What's in the Box

This rear axle breather will stop lube from being flung out of rear axle housing. Allows "breathing" of rear axle assembly. 7/16"-20 thread. Polished!

Install with thread sealant or Teflon tape. Can be used on various applications with appropriate plumbing components.

Application

  • You will have to drill and tap rear cover 92547004 to use this breather.

 

Specs


You may also be interested in:

Rear Axle Breather, AN4 Bulkhead
                        

The pleated high efficiency breather comes with an AN4 bulkhead fitting and nut. AN4 fitting is 7/16 x 20 thread. Filter has hose clamp to tighten lower rubber flange to bulkhead fitting. Rubber lipped base of filter accepts 1/2" fitting and can be adapted to a 1/4" pipe nipple if desired. Can be used on various applications with appropriate plumbing components.

Filter is available separately under part number 465-621330.

Drive Shaft Safety Loop
                        This driveshaft safety loop holds the drive shaft in place in case of universal joint failure. Made from 2" x 1⁄4" hot rolled steel with grade 5 bolts. Bolt-on installation.
                    
Leaf Spring Pinion Angle Shims
                        These aluminum leaf spring shims allow you to correct your pinion angle. Availalbe in 2° and 4° angles. Fits 2-1/2" wide springs.
                    
Crankcase / Rear End Axle Breather Vent Filter Only, 1/2 Inch
                        

These billet rear-end breathers provide a convenient way to vent rear differentials, transmissions, and other components. They're easy to use--just clamp them on to a roll bar and no welding is required.  These clamp-on style crankcase vent filters are washable for easy clean up and reuseable.

Crankcase/Rear End Axle Breather Vent Filter Only

  • Clamp on design, no welding required
  • Includes vent, hardware, and hose for a quick professional installation
  • Differential Vent Thread Size (in):  0.125
  • Differential Vent Head Style:  Round
  • Differential Vent Material:  Steel/Rubber
  • Differential Vent Finish:  Chrome
  • For 1/2" connection

 

Speedway Weld-On Spring Pad for 3 Inch Axle Tube
                        

These weld-on leaf spring pads fit 3" diameter axle tubes. Works with all 2-1/2" wide leaf springs.