Since 1952
America's Oldest Speed Shop ®
Speedway Motors Bill Smith

Performance Tool W3939 Small 2-1/2 Inch Drill Press Vice


Share by Email


Click image to enlarge




Q & A

What's in the Box

Handy tool for when using the drill press. Has 2-1/2" wide jaws. Jaws spread apart 2-5/16" when completely extended.

  • Slot design mounting holes
  • Etched jaws for preventing slipping
  • Pivot handle for easier turning

You may also be interested in:

PipeMaster P-T125 Contour Gauge for 1-1/4 Inch O.D. Tubing

Fabricating roll cages, tube chassis and countless other race car or hot rod components just got a lot easier with PipeMaster tube contour gauges.

These simple-to-use tools help you lay out complicated tube joints in seconds and save time and material by providing accurate cut lines. Sturdy contruction features stainless steel pins, an aluminum inner shell and rugged ABS housing.

Instruction Sheet (PDF)

Center-It Drill Press Block
                        With this great little tool you will no longer struggle trying to drill a hole in a piece of round tubing. Once set-up, its centered for all sizes. 
Intercomp 102144 Digital Angle Gauge
                        New digital angle finder reads from 0° to 90° in .05° increments.  Large backlit LCD display rotates characters 180°.  Measures 2.25" square, has magnetic base, and uses a 9-volt battery.