This Turbo 350 transmission dipstick features braided stainless covered dipstick tubing with billet look handle and stainless hardware. Flexible design gives added mounting versatility. Attaches at bellhousing near starter.
Red Line Oil’s team of chemists and blenders formulate fully-synthetic engine oil using only the world’s finest base stocks. This makes Red Line Motor Oil the premium product on the shelf. It’s not designed to be the cheapest – it’s built to be the best. Rather than cutting cost by blending into polyalphaolefin base stock for it’s motor oil, Red Line Oil only uses superior polyester-based products – resulting in lubricants that are extremely stable at high temperatures while providing superior film strength at lower viscosities where more power can be produced.
These billet aluminum adapters allow you to put an LS1 where a S/B Chevy would mount. They bolt to the sides of your LS1 and accept standard S/B Chevy mounts. Metric and Standard hardware included.
Note: These motor mounts may require you to move your transmission mount forward in some applications.
916-18016 Instructions (PDF)
You will need the correct throttle cable for your LS1 / 350 Ramjet swap. This cut-to-fit cable looks good and gets the job done.
Clean up your LS1 intake manifold with this billet aluminum cable bracket. Available with a single stud for throttle only or a double stud to add cruise control or kickdown cable. Designed to work with part #491-1000LS1.
You will need the correct throttle cable for your LS1 / 350 Ramjet engine swap. This cut-to-fit cable looks good and gets the job done.
This billet aluminum bracket mounts to the side of the LS1 manifold and is comes with a single stud for throttle only.
Flexible Engine Dipstick designed with billet aluminum handle to coordinate with Lokar's Flexible Transmission Dipstick. Slim design allows mounting inside headers. Designed for use with factory, Sanderson cast manifolds or block hugger headers. E-Z read flexible inner dipstick measuring cable for accurate measure of engine oil.
Looking for more shine in your engine compartment? Try Lokar's Polished Hi-Tech Throttle Cables. Lokar's polished cables are available in stainless steel braided housing or black housing. They are designed with a specially extruded liner for extended life of the cable – not to be confused with ordinary braided brake hose. Cables are equipped with polished aluminum fittings and polished aluminum ferrule to eliminate fraying. "U-Cut-to-Fit" outer housing is available in 36" lengths with a "U-Cut-to-Fit" stainless inner wire. Clevis is designed without cotter pins or set screws. Adapts to factory and aftermarket pedals. Cables mount nicely with Lokar's array of bracket and return springs (sold separately). Kits complete with installation instructions. Pair up with a polished kickdown.
Throttle Body and Carb End Fittings Guide (Link)
491-001000 Instructions (PDF)
Lokar Hi-Tech Throttle Cable features a stainless steel braided housing. They are designed with a specially extruded liner for extended life of the cable – not to be confused with ordinary braided brake hose. Cables are equipped with aluminum fittings and aluminum ferrules to eliminate fraying. Kits come complete with installation instructions.