Since 1952
America's Oldest Speed Shop ®
Speedway Motors Bill Smith

LS Low Oil Level Sensor Plug

SAME DAY SHIPPING!

Specs
Sold in Quantity:
Each
Wrench Type:
Hex
Thread Pitch:
20MM-1.5
Wrench Size:
1" SAE
Gasket(s) Included:
Yes

Share by Email

From
To

Click image to enlarge

X

Details

Reviews

Q & A

What's in the Box

There's a pretty good chance you aren't using the low oil level sensor that is sticking out of the oil pan on your LS engine. These plugs replace the sensor and clean the pan up. Fits 99-up Vortec and 97-up Corvette and F-body LS1 oil pans.

  • Thread Diameter:  20mm O.D. (25/32")
  • Wrench Size:  1"

You may also be interested in:

Auto Meter 2268 LS Series Oil Pressure Sender Adapter
                        

This LS Series oil pressure sender fitting allows your aftermarket 1/8" NPT oil pressure sending unit to be installed in place of the OEM oil pressure sender.

When installing aftermarket gauges, the OEM oil pressure sender is not required by the PCM and may be replaced by the aftermarket sender of your choice.

Auto Meter 2277 LS1 Water Temperature Sender Adapter
                        

This LS Series water temperature sender fitting allows your aftermarket 1/8" NPT water temperature sending unit to be installed in your passenger side cylinder head.

Note: I.D. of this adapter where the sender probe will go through is .309 and would require drilling to approximately 5/16" or .312 for a Stewart Warner sender to pass through.

LS Low Oil Level Sensor Plug w/ 1/8 NPT Port
                        

There's a pretty good chance you aren't using the low oil level sensor that is sticking out of the oil pan on your LS engine. These plugs replace the sensor and clean the pan up. If you want to run an oil temp gauge, order the plug with the 1/8” NPT hole in it. Fits 99-up Vortec and 97-up Corvette and F-body LS1 oil pans.

  • Thread Diameter:  20mm O.D. (25/32")
  • Wrench Size:  1"
Auto Meter 5284 GM LS Engine Gauge Adapter Kit
                        

Swapping an GM LS or LQ series engine into your project and trying to figure out how and where to connect all your gauges? This is what you need! This LS Install Kit from Auto Meter includes a full color booklet with step by step instructions and photos documenting the most common installation points for essentials like oil pressure, coolant temp, RPM and more! In addition to the handy manual compiled by Auto Meter's R&D staff, the kit also includes a package of commonly used adapter fittings to assist with the mounting of your gauge sensors, a short depth temperature sensor specific to the LS / LQ installation requirements, and a pull up resistor used when connecting a tachometer to your engine's ECU.

Includes;

  • 10,000 Ohm Pull Up Resistor
  • 1/8"NPTF Short Depth Eletric Water Temp Sensor
  • M16x1.5 Male to 1/8" NPTF Female adapter for oil pressure
  • M12x1.5 Male to 1/8" NPTF Female adapter for water temperature
  • For installation of Auto Meter Full Sweep and Short Sweep Electric Gauges ONLY!