Holley 20-12 Accelrator Pump Cams
Click image to enlarge
Q & A
What's in the Box
Includes eight assorted pump cams to fine-tune your accelerator pump shot. Accelerator pump shot relative to cam color from lightest to heaviest are as follows: White, Blue, Red, Orange, Black, Green, Pink & Brown.
- Tailor Accelerator Pump Performance
- Each Cam Is Different Shape/Profile
- Gives Different Results
You may also be interested in:
Jet WrenchMore Info
Holley 135-7 50cc Accelerator Pump DiaphragmMore Info
Holley Accelerator Pump Discharge NozzlesMore Info
Holley 135-9 50cc Accelerator Pump Diaphragm, AlcoholMore Info
Wehrs Machine WM47 Carburetor FeetMore Info
No need to remove your carburetor or distributor to handle jet replacement, with Speedway Motors' Holley Jet Wrench!
Speedway has been racing for more than 50 years, and saw the need for a handy wrench to make Holley rear jet replacement easier. The wrench's precision designed tip fits snugly into the jets. Poor fitting and misaligned screwdrivers can cause external jet damage and affect fuel flow.
The short size and 90-degree end provides just the angle needed to properly loosen and snug jets into place, while easily working between the distributor and carb. The opposite end of the wrench is designed to handle bowl screw removal, opening the gas level plug, as well as float screw adjustment.
Holley accelerator pump diaphragms are available in 30cc (427-1355) or 50cc (427-1357) sizes. For use with gasoline only.
A good selection of pump discharge nozzle sizes is indispensable to the proper tuning of the accelerator pump system. The nozzle hole size determines the rate of fuel discharge. A larger hole will "shoot" the fuel at a faster rate with less pressure than a smaller hole. Sizes are stamped on each nozzle. For example the number "31" indicates the nozzle hole size is .031".
Includes one nozzle and two nozzle gaskets.
The three styles offered are Tube Type, Straight Type, and Center Type.
Holley GLFT 50cc accelerator pump diaphragm for use with all alcohol base fuels.
Bolt to the base of your carburetor so you can work on it without damaging the throttle assembly.
- 5/16”-18 threads
- 1-1/2” tall
- Set of 4 (nuts included)