Since 1952
America's Oldest Speed Shop ®
Speedway Motors Bill Smith

Hilborn 327C8A-SPBASE Mechanical Fuel Injection for 305 Cast Iron Head


Share by Email


Click image to enlarge




Q & A

What's in the Box

The Hilborn Raw Injectors pick up where the Basic Injector leaves off. This injector will fit standard 23 degree 305 Chevy cast iron heads. Utilizing a curve throat design, the raw injection provides minimal flow disruption, allowing outstanding port speed for maximum cylinder fill. Hilborn injectors come with numerous standard features that prove once again, you get more value from Hilborn Fuel Injection.

This aluminum raw Fuel Injector is designed primarily for oval track and features a 3-piece construction for precision port matching of head and block combination. Unit comes with throttle return springs, breathers, lines, primary and secondary by-pass valves, linkage, 4 pills, and instructions. All units are factory flow-tested.

Note: Does not include nozzles or stacks - they must be ordered separately.

Item Details

2-3/16" for 305 Chevy Head

You may also be interested in:

Hilborn Fuel Injection PG150CS0 Fuel Pump, 1.7 GPM

The Hilborn direct drive fuel pump has a new billet style rotatable mount. Direct drive and flow-tested. Gives long-lasting, rugged dependability. Convenient quick disconnect. For use with injection or alky carbs. Features hard annodized, aluminum construction. The clamp base model offers you the convenience of a quick disconnect. This pump can be rotated for easy access to fittings.

All pumps rated at 1800rpm with 50psi. Has one -10 AN inlet and two -6 AN outlets.

Hilborn 708A-1/2-AS-#10AS Injector Nozzles #10 Up, 1/2 Inch Tip, Set/8

Each Hilborn nozzle has 1/2"-20 straight threads. Sold in sets of eight.

Hilborn Fuel Injection F1043F-12 Injection Stack, 2-3/16 Inch
                        Lightweight steel. 12" tall with rolled bell for more air flow. These fuel injection stacks are sold individually, so you must purchase eight to get a complete set.