Since 1952
America's Oldest Speed Shop ®
Speedway Motors Bill Smith

Grand National Rear End

SAME DAY SHIPPING!

Share by Email

From
To

Click image to enlarge

X

Details

Reviews

Q & A

What's in the Box

To help keep the cost of this full floating Ford 9 inch rear end down, This Grand National rear end assembly uses reclaimed original housings with new 3" tubes and ends. They have been cleaned and jig-welded to ensure straightness. Everything else is brand new and includes 31 spline axles, hubs, drive plates, 5/8" studs, bearings, seals, rotors and lug nuts.

Choose 58" or 60" width, centered pinion. Choose 5 on 5" or 5 on 4-3/4" bolt circles. 

You may also be interested in:

Ford 9 Inch Third Member Assembly, Full Spool, 31-Spline
                        
  • Professionally assembled for oval track racing only
  • Includes Pro Gears ring & pinion
  • Your choice of gear ratio, 3.50:1 to 7.33:1
  • Includes 3-5/8" stock Ford yoke
  • Viton high heat pinion seal
  • Solid pinion bearing spacer with shims
  • Plastic storage case

910-48343 Instructions (PDF)

Third members are made to order. Please allow 24-48 hours for order to ship.

Order applicable spool:

  • STD = Standard
  • LITE = Lightweight
  • MEGA = Megalite

Available options include machining of the yoke to accept Chevy/GM U-joint (add 91048339) and lightening of the ring gear to remove weight (add 91600013; 5.37:1, 6.66:1, 6.83:1, 7.00:1 ratios are already lightened).

DRP Performance 10518 Grand National Rear Hub Bearing Spacer
                        

These hub bearing spacers allow for consistent and precise bearing load every time the spindle nut is tightened, regardless of the torque applied. Without a bearing spacer, bearings are typically over tightened to prevent loosening during the race. With a bearing spacer installed, you can completely tighten the spindle nut and the hub will spin free every time. Bearing spacers save time, reduce bearing temperature and greatly increase wheel free spin, putting more horsepower to the wheels. You can feel the difference by simply pushing the car!

Testing has shown that the bearing spacer will make more difference than any “Low Drag” bearing set up currently available. When the spacer is used in conjunction with “Low Drag” Tapered bearings and seals, you will have the ultimate Low Drag set-up. These adjustable bearings feature a threaded sleeve and set screw to ensure you'll never have to worry about an over-tightened hub again!

  • 2.5” Short Track 5×5 Rear
  • Adjustable
  • 200%-300% more free spin vs. no spacer
  • Designed to fit all Grand National spindle and hub combinations
  • Makes servicing hubs simple & quick
  • Bearings run cooler
  • Saves time
  • Eliminates bearing “Spin” on spindle
  • Distributes side load evenly across bearings
  • Works on tapered and angular contact bearings
  • Once Set, typically never has to be adjusted unless bearings or hub is replaced
  • Instructions Included
  • Precision Machined in the USA
  • +/- .001” Minimum Parallelism
  • Sold each