Since 1952
America's Oldest Speed Shop ®
Speedway Motors Bill Smith

Edelbrock 2921 Victor Jr. Ford 302 Intake Manifold


MFG. Part #:
Intake Manifold Type:
Single Plane
Carburetor Quantity:
Carburetor Flange Type:
4-Barrel Square Bore

Share by Email


Click image to enlarge




Q & A

What's in the Box

The Edelbrock Victor Series intake manifolds have set the standard for quality and performance in the racing industry. The Victor Jr. 302 is designed for Ford 260-289-302 competition engines using modified stock cast iron or aftermarket Windsor-style cylinder heads.

The Victor Jr. 302 has no rear water crossover. Port exit size at cylinder head is 1.90" x 1.08" with enough extra material to open it up to 2.10" x 1.18".

325-2921 Instructions (PDF)


  • Manifold height @ front:  5.50"
  • Manifold height @ rear:  5.50"
  • Port exit size:  1.90" x 1.08"

You may also be interested in:

High Flow 4150 Holley Carb Spacer
                        This hi-tech carb spacer straightens out and increases air velocity into the intake manifold.
  • 1" thick and standard 4150 bolt pattern
  • Fits 4 barrel 4150 Holley carburetors
Fel-Pro Gaskets 1250 Small Block Ford Intake Gasket Set-1.20x2.00 Port

Fel-Pro Blue Stripe intake manifold gasket sets for 1962-1986 Ford, Mercury V8 260, 289, 302 (except "BOSS") and 351W V-8.

Percy's 66021 Seal-4-Good Reusable Base Plate Gasket
                        Advanced EMR polymer insures reusability. Will not stick like ordinary paper gaskets. Allows quicker carburetor removal and replacement.  Gasket is 0.0640" thick.
Carburetor Stud Kit, 2 Inch
                        Easy installation/removal of carb plates. Includes zinc plated steel studs, nuts and washers. 
Weiand 289-302 Ford IMCA Approved Manifold

If you run IMCA Stock Car or Sport Mod this is the Weiand intake manifold you can run.For S/B Ford 221, 260, 289, 302 V8. With an effective rpm range of 1500 to 7000 rpm, this intake works best with a higher compression ratio, 280° or more of cam duration and headers with 1-5/8” primary tubes. The Weiand X-CELerator Series is the ultimate performance manifold for single 4V applications where increased torque and power is required in the mid and high rpm ranges.


  • IMCA Approved
  • 360° Single Plane
  • Open Plenum
  • Square Carburetor Mounting Flange
  • IMCA Approved
  • Power band: 1500-7000 RPM
  • Will NOT fit 255, 351W or Boss 302 engines


805-7515 Instructions (PDF)
Caburetor Stud Kit, 1 3/8 Inches

Caburetor Stud Kit, 1 3/8"

Easy installation/removal of carb plates. Includes zinc plated steel studs, nuts and washers.

Open 4 Barrel Carburetor Base Gasket
                        Open base gaskets.