Bills Hot Rod Co. Power Steering Pump Brackets for Small Block Chevy
Click image to enlarge
Q & A (3)
What's in the Box
Fabricated from 1/4" mild steel with stainless/chrome Allen head hardware. Simple installation; all brackets are pre-assembled. Drilling or tapping is not required. Attaches to the lower left front of the block using the two lower bolt holes located by the timing cover (the old front motor mount holes). The adjusting arm mounts to the lower water pump hole.
- Mounts low on drivers side
- Two positions for superior adjustability
- Works with short style water pumps
- Use with GM Saginaw pumps with attached reservoir, "type 1" p.s. pumps
- Works with stock steel or aluminum aftermarket pulleys
- Choose black or chrome finish
Item DetailsWorks with short style water pumps.
Bracket mounts to the lower left front of the block using the two lower bolt holes located by the timing chain cover (the old front motor mount holes). The adjusting arm mounts to the lower water pump hole.
Bracket will fit a wide range of applications due to its two mounting positions: LOW and HIGH
Bracket fits a G.M. Saginaw power steering pump with attached reservoir.
Brackets are made of 1/4" mild steel plate for strength and durability.
All brackets are made in the U.S.A. Brackets come completely assembled with all stainless steel bolts and washers, an illustrated instruction sheet and belt size recommendations with adjusting tips.
If power steering is used with bracket # 91667920, the power steering belt makes use of the third groove (farthest foward groove) on a three groove pulley (our pulley # 91015480).
You may also be interested in:
Black Double Groove Power Steering Pulley, ChevyView$34.99Compare
Black Single Groove Power Steering Pulley, ChevyView$29.99Compare