AFCO 9850-6221 Straight Vane Brake Rotor, 12.19 x .81 Inch
Click image to enlarge
Please note the following about this product:
- Ground Shipping Only - Can't Ship Air.
Q & A (0)
What's in the Box
AFCOs disc brake rotors set the pace for design, quality and performance. Special designed materials, enhanced computer imagery and design, as well as extensive lab and track testing have yielded a superior brake rotor. All AFCO rotors have been optimized for strength, weight, and heat dissipation ability to meet the demands of the serious racer.
- Premium grade alloys for superb thermal shock stability
- Machined and blanchard ground to assure precise flatness
- Precise vane placement for high volume cooling
Item Details8 x 7" Thru
Proper Break-In Procedure for Steel or Cast Iron Rotors
New steel/iron rotors should be bedded in before being used in racing conditions. Proper bedding will prepare the rotor surface, prolong the rotor's life, and make it more resistant to thermal checking or cracking under severe braking conditions. The following procedures should be performed when bedding in both steel and cast iron rotors. It is best to bed in a new rotor using a used set of pads, preferably ones which will not create heat rapidly. Generating heat too rapidly will thermal shock the rotors. Likewise, when bedding in a new set of brake pads it is best to perform the process on a used rotor. This new/used bedding process permits controlled bedding of each individual component.Make sure rotor surfaces are free from oils, grease, and brake fluid. Run vehicle up to a moderate speed and make several medium deceleration stops to heat up the rotor slowly. This will help reduce the chance of thermal shock caused by uneven heating of the rotor. Pull into the pits and allow the rotor to cool to ambient air temperature. Care should be taken not to ride the brakes into the pits as this may hot spot the rotor causing premature wear to the surface or structural damage.
This product has no reviews.
No questions have been asked.
You may also be interested in:
Wilwood 160-5865 Ultralite 32 Vane Drilled Vented Iron Rotor, 12.19 InView$51.99
Quick ViewQuick View Detailsx
When it comes to brake rotors, racers are constantly searching for the ultimate balance between the lowest weight and the ability to effectively manage heat. Decreased rotating weight in the drive line provides quicker deceleration under braking and quicker acceleration out of the corners. Lower weight also benefits handling with improved spring and shock control over the unsprung suspension mass. Wilwoods ULD-32 drilled iron rotors provides effective lightweight options for sprints, late models, modifieds, and other competition applications that race in low to medium temperature ranges.
- Cast from premium grade, long grain carbon iron
- Close tolerances on face and vane thickness
- 32 straight vane casting provides superior heat management and long service life
- Two row, 64 hole pattern - alternates between and directly over each vane
- Each hole deeply chamfered to eliminate stress points
- Rotating and unsprung rotor mass reduced by 12%
- Left or right hand mounting locations
Item Details0.81" x 12.19"
8 x 7.00" B.C.Compare
Speedway Pro-Lite Vented Brake Rotor, 12.19 x .81 InchView$24.99
Quick ViewQuick View Detailsx
Every brake rotor is cast from premium grade, long grain carbon iron which exhibits long wear, high thermal stability, and excellent resistance to distortion in high heat. Modern foundry and machining techniques hold close tolerances on face and vane thickness. Combining the correct face thickness with a 32 vane casting provides superior heat management and long service life with low rotating and unsprung weight. The straight vane design also makes it possible to use the same disc brake rotor on left or right hand mounting locations.
- Thickness: .81"
- Outside Diameter: 12.19"
- # Holes: 8
- Bolt Circle: 7"
- Thread: Thru
- Weight: 8.70 lbs