Mounts Model T lamps to the cowl. Use with 9-1/2" cowl/taillight only. Mounting holes are 2" center to center The mounting holes are 3/8" square Mounting bolts are NOT included
These billet aluminum mounting brackets are for our Linear Actuator 910-64290. They are designed to mount your linear actuators to hoods, trunks, etc. on either flat or angled surfaces. Solid aluminum construction provides the greatest strength possible while remaining a great looking piece. The brackets are a satin finish, but can be polished to a bright shine. Sold individually - you may need two mounts (one for each end of the actuator). Includes bracket and three securing screws. Billet aluminum Satin finish Mount linear actuators to hoods, trunks, etc. Mount ...
Use these AFCO 1/8" thick steel plates to mount radius rods, brake rods, third link, Panhard bars, etc.
Weld these brackets to the underside of your low-ridin' 'T' thru 1934 Ford frame rails for a simple, strong place to attach 4-bars or radius rods. Plain steel. NOTE: For use with spherical rod ends.
Weld these brackets to the underside of your low-ridin' 'T' thru 1934 Ford frame rails for a simple strong place to attach 4-bars or radius rods. Plain steel.NOTE: For use with spherical rod ends.
Tank mounting bracket for Peterson 6" diameter 2.5 gallon dry sump tanks # 08-0827 08-0827 (-16 Return) and 08-0828. Sprint car tank bracket bolts directly to the front of the small block Chevy engine. Fabricated from aircraft quality aluminumUses stainless steel straps for durability
Mounts 1978-1988 GM front caliper to any 3" tube rear end using 11-3/4" diameter rotors. Fully machined steelwith punched lightening holes. Measures approximately 5-1/2" between mounting holes. IMCA APPROVED
Use these AFCO 1/8" thick steel plates to mount radius rods brake rods third link Panhard bars etc.
You can weld these brackets to your 9" Ford housing and install it in your GM Metric chassis. Includes upper and lower control arm mounts. Welding required. Designed for 3-1/2" axle tubes but can be fit to 3" tubes. ThisDeluxe rear end bracket set features multiple holes (5) for mounting the lower control arms. Alsoincluded is a pair of weld-on brackets for mounting the Metric brake calipers. The lower mounts in this kit have only one shock mount position. This kit isNOT IMCA Hobby Stock legal but is IMCA Stock ...