Bill Smith
Founder, 1929-2014
Speedy Bill
Since 1952
Speedway Motors Logo
America's Oldest Speed Shop ®


1978-1988 GM Metric Pitman Arm

SAME DAY SHIPPING! Order within the next 8 hours 55 minutes and receive same day shipping

Sold in Quantity:
Hole Diameter:
Degree of Taper:
10 degree
Center to Center:
Top of Taper:
Bottom of Taper:
Spline Count:
32 and 4 master
Fits Sweet and GM 800 boxes.
1978-1988 GM Metric Pitman Arm

Click image to enlarge



Q & A

What's in the Box

We all know how hard it is to find GM pitman arms and they're a pain to take off. These 1978-1988 GM Metric pitman arms are used. We clean and inspect each one.

Customer Reviews

Rated 4 out of 5 by 1 reviewers.
1 reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star

Turner Racing
Verified Purchaser
Peoria, IL
Product Rating

I would but this product again

September 18, 2011
Good Product,readily available, excellent quality, next day shipping
  • Easy To Install
Yes, I recommend this product.
Full Size Image

Was this review helpful? 0 0

Page 1 of 1

Product Q&A

4 questions : 5 answers

1 answers

Will this fit the GM 800 steering box

August 24, 2014

Will this fit the GM 800 steering box


August 25, 2014
Yes this fits GM 800 series boxes.
1 answers

will this fit a sweet 8.1 or 6.1 box??

June 17, 2014

will this fit a sweet 8.1 or 6.1 box??


June 17, 2014
Yes this will fit all of the Sweet steering boxes that I carry.
2 answers

Is this for the snapring box or the 4 bolt box Thanks

January 10, 2011

Is this for the snapring box or the 4 bolt box Thanks


January 02, 2012
flying dutchman
this is for a four bolt box like the GM 800 the snapring box has a smaller shaft diameter
January 12, 2011
The pitman arm you specify has the following features: 6.5" center of eye to center of eye Splines are 1.212" outside diameter Bottom of tapered hole is 0.585" Top of tapered hole is .5" 1.813" drop I have no reference that indicates whether it is from either of the boxes that you mention. It is typically used on the 1978-1988 GM mid-size cars (Monte Carlo, Regal, Cutlass, etc.).
1 answers

What tie rod ends does this work with?

Birmingham Mi
May 07, 2015

What tie rod ends does this work with?


May 08, 2015
These work with stock 1978-1988 Gm metric cars drag links. That will include Monte Carlo, Regal, Cutlass, El Camino, Malibu and Grand Prix models
Page 1 of 1

You may also be interested in:

1964-88 GM Power Steering Box, 3/4 Inch 30-Spline Input
(Part #91032500)

Remanufactured GM 800 Series power steering boxes have a 16:1 ratio and were used in midsize GM cars from 1964-1988. Painted black and include -6 AN fittings to make it easier to fabricate hoses if needed. Pitman arm not included. No core return is required.

Note: Not compatible with OEM 45° flare fittings.

Red Line 30404 Power Steering Fluid
(Part #60710006)

Red Line Oil’s team of chemists and blenders formulate fully-synthetic oils and chemically-advanced additives using only the world’s finest base stocks. This makes Red Line Oil the premium product on the shelf. It’s not designed to be the cheapest – it’s built to be the best. Rather than cutting cost by blending into polyalphaolefin base stock for it’s motor oil, Red Line Oil only uses superior polyester-based products – resulting in lubricants that are extremely stable at high temperatures while providing superior film strength at lower viscosities where more power can be produced.

The world’s top racing team and most discriminating enthusiasts use Red Line Oil products exclusively. There may be a different sponsor on the outside, but chances are it’s Red Line Oil on the inside.

  • Helps prevent high-temperature steering fade
  • Helps prevent difficult low-temperature steering
  • Greater heat resistance
  • Helps prevent high-temperature boil-over
  • 50% greater high-temperature viscosity
  • 1/5th the high-temperature evaporation
  • Helps prevent leakage and squealing
  • 1/4th the oxidation of petroleum power steering fluids
  • Compatible with petroleums and synthetics
  • Also satisfies API 75W GL-4 gear requirements
Power Steering Hose Kit, -10 AN Reservoir
(Part #91032960)

This power steering hose kit is just what you need to plumb your driver's side remote reservoir power steering set up. The AN 10 hose kit includes 4' of AN 6 high pressure hose, 5' of AN 6 blue aeroquip hose and 3' of AN 10 blue aeroquip hose  One 45° AN 6 and one 90° AN 6 fittings are included as well as an AN 6 straight brass push-on and one AN 6 and two AN 10 90° push-on hose ends.

NOTE: Does NOT contain steering box fittings