1970-76 GM 10-Bolt Mini Spool
Click image to enlarge
Q & A
What's in the Box
910-48601 Instructions (PDF)
Item Details8.5" ring gear, 28 spline
This product has no reviews.
No questions have been asked.
You may also be interested in:
Cross Pin GM 10 Bolt 8 1/2 Inch Ring & PinionPrice: $24.99More InfoCompare
GM 10 Bolt Ring and Pinion Instal Kit, 8.5 R&P, 30 SplineMore InfoCompare
GM 8.5 Inch 10-Bolt Steel Full Spool, 28-SplinePrice: $145.99More InfoCompare
Lubrication Engineers SAE 90 Weight Gear Oil, 1 GallonMore InfoCompare
Rear Axle Breather, AN4 BulkheadMore InfoCompare
Special 4130 Chromoly cross pin required for ratios of 5.38 or higher.
Everything you need for a complete ring and pinion installation job.
- cover gasket
- crush sleeve
- marking compound and brush
- pinion and carrier bearings
- pinion nut and washer
- pinion seal
- thread locking compound
Note: Pinion-depth shims are not included.
Item Details30 Spline Pinion
This is a steel full spool made from 4130 aircraft alloy heat treated steel.
Whether you're running a stock flattie and rearend or hopped-up overhead and quick change, you need to run a good gear lube. Remember that your rearend was designed fifty plus years ago and needs all the help it can get.
The biggest improvement you can give it is a lubricant that will allow the gears to survive the highway speeds that cars see today. L.E. gear oil is what we use in our 350 mph streamliner, that uses a V-8 quick change, without failure. The "red stuff" provides superior lubrication for long gear life. You can't win if you don't finish. We suggest 90 weight for the street and 140 weight for extreme uses.
- Formulated using blends of high quality paraffinic and synthetic base fluids
- Contains a highly shear stable tackiness
- Unique blend of base fluids and thermally stable EP additives
- Separates readily from water
- Contains non-silicone defoaming additives
- Contains no solids
- Contains DUOLEC LE's proprietary dual acting liquid wear-reducing and extreme pressure additive
The pleated high efficiency breather comes with an AN4 bulkhead fitting and nut. AN4 fitting is 7/16 x 20 thread. Filter has hose clamp to tighten lower rubber flange to bulkhead fitting. Rubber lipped base of filter accepts 1/2" fitting and can be adapted to a 1/4" pipe nipple if desired. Can be used on various applications with appropriate plumbing components.
Filter is available separately under part number 465-621330.