No items in Shopping Cart
These are a chassis type header and feature:
Use the these measurements to determine if they will work on your application:
had to install header bolts from rear to front in sequence to counter the header hitting the frame.
Speedway has excellent service and great prices.
Get your questions answered by the community. Ask or answer questions below.
Are the bolt holes straight across where the header bolts to the head? It appears as though they are in the picture. I have some Ram horn manifolds but the bolt holes on both ends are higher and not aligned with the center bolt holes, consequently they won't work.
Asked on 1/25/2011 3:08:31 AM by John Sloan from West Blocton, AL
These headers p/n 9308422 are designed to fit 1953-64 Ford F100 pick-ups with a 272-312 Y-block engine. They feature an offset bolt hole on the outside end tubes to match the cylinder head bolt pattern. They have 1-5/8" primaries and 3" collectors and the set comes with bolts, gaskets, and reducers. The reducers are 3" at the inlet end, 2-1/4" OD at the outlet end.
Answered on 1/27/2011 4:20:09 AM by Bill from Speedway Motors
Will these fit a 239 y-block 54 effie,thanks
Asked on 1/29/2011 12:58:08 AM by opeym from weirton wv.
The 1953-64 F100 Y-BLOCK HEADERS, Item #: 9308422, are designed to fit 1953-64 Ford F100 pick-ups with a 272-312 Y-block engine.
Answered on 2/3/2011 2:15:22 AM by Waymon from Speedway Motors
I have a 58 Ford F100 with a 292 will it pass the 3 on the tree linkage?
Asked on 8/1/2011 3:53:13 PM by opeym from weirton wv.
* These headers do not carry any notation or warning pertaining to the stock 3 speed column mount linkage and from the photo the configuration tends to confirm that they should clear. Some dimensions to work with for fit verification is as follows: A = 5" - From head surface at flange to the outermost part of the header tubes. * B = 19" - Top of header flange to lowest point of header tubes. * C = 30" - Front of header flange to farthest point rearward at collector. For further specifications and fit verification you may want to check with Pertronix (manufacturer) direct.
Answered on 8/3/2011 5:04:11 AM by John from Speedway
I have a 57 Ford F250 with a 312 and I would like to change the crossover manifold setup. It is a manual 3-speed with no power steering. Will these headers clear the steering box and linkage? If not, then what header would you recommend?
Asked on 10/2/2011 12:45:04 PM by opeym from weirton wv.
These headers are designed to fit the 1953 to 64 Ford F100 pickups and should also work on the ¾ and 1 ton applications. For verification you can take some basic dimensions for comparison. * A = 5" - From head surface at flange to the outermost part of the header tubes. * B = 19" - Top of header flange to lowest point of header tubes. * C = 30" - Front of header flange to farthest point rearward at collector.
Answered on 10/4/2011 4:08:36 AM by John from Speedway
Do you have a question about this product?